Tango+ Setup; Tango+ Hardware Setup - SunTech Tango+ Guia Del Usuario

Tango+ Setup

Tango+ Hardware Setup

Your Tango+ will come with a power supply, a patient cable, and an Orbit-K cuff(s)
with a microphone.
a. Connect the power supply to a power cable and plug the cable into an avail-
able outlet.
b. Connect the power supply (P/N 19-0012-00) to Tango+ (See Figure 1). The
monitor will turn on. If the monitor is attached to a stress system, the Tango+
will turn on and off along with the stress system.
c. Connect the patient cable (P/N 91-0001-00) to the K-sound Microphone and
Pneumatic Hose Connector on the rear of the Tango+ (See Figure 1).
If the Tango+ has the Internal ECG option, the unit will come with an ECG patient
cable (P/N 91-0004-00). Connect the ECG patient cable to the Internal ECG con-
nection on the rear of the Tango+ (See Figure 1).
DC Power In
BNC External ECG
RS-232
SpO
(optional)
2
Power Reset Switch
Figure 1: Rear panel connections
Warranty Seal
Pneumatic Hose
Connector
K-Sound Microphone
Connector
Internal ECG
(optional)
7