Product Information - Be Cool Pick Up Manual Del Usuario

GB
INTRODUCTION
1
The Pick Up car seat is designed for instal-
lation in most vehicles equipped with Isofix
anchor points, always in combination with the
safety belts of the car. Your vehicle's compat-
ibility can be verified by checking the Com-
patibility list.
Important: According to European classifica-
tion, the Pick Up car seat is Semi-universal
seat. This means that they must only be used
in the vehicles indicated on the Compatibility
list.
READ THIS MANUAL CAREFULLY BEFORE
USE AND RETAIN FOR FUTURE REFERENCE

Product information

This car seat has been designed and tested to
comply with the latest European standards for
Group 2 & 3 car seats.
This car seat has been designed for children
weighting from 15 to 36 kg, of approximately
4 to 11 years of age.
All ages given are approximate since all chil-
dren grow at different rates. However, the
weights given are the main safety issue.
To improve your child's safety, the Pick Up car
seat is fitted with:
-ISOFIX connectors, to fit Isofix anchor points.
-Belt guides for adult seat belts.
-Low back rest to support your child's lumbar.
General Information
In order to protect your child adequately and
make sure that they are comfortable and se-
cure inside the car, you must follow these in-
structions:
-Your Pick Up car seat has been designed to
be installed in either the front or rear of a car,
providing that you have three-point safety
belts and that there is NO FRONT AIR BAG.
Despite this, we strongly recommend that you
install your Pick Up car seat in rear seats only,
as this will ensure maximum safety.
Figure 1. Forward facing installation
Figure 2. Positioning in the car
Only valid for cars fitted with automatic,
three-point safety belts, approved in accord-
ance with the ECE-16 standard or other equiv-
alent standards ( Figure 3) .
Do NOT use with a two-point safety belts
(Figure 4). These are very dangerous should
you brake suddenly or in the event of an
accident .
In some cars, the safety belt clasp might be in
a very high position and may come into contact
with the edge of the booster seat, making this
position unsafe . In this case, trying to move
the Pick Up car seat forwards, or installing it
on a different seat . If you have any doubts,
contact your local distributor or retailer.
-Not all safety systems are exactly the same,
so we recommend that, where possible, you
first try the Pick Up car seat in the car in which
you are going to install it.
-It is very important not to use second-hand
products, as BE COOL can only guarantee
complete safety for items used by the initial
buyer.
-BE COOL recommends that you replace your
Pick Up car seat with a new one following any
accidents.
-Ensure that all the belts are in their correct
positions and make sure that no belt is coiled up.
Make sure the child understands that under
no circumstances should they interfere with
the belts and fastenings.
-The Pick Up car seat has been designed to be
used in passenger vehicles only, and must not
be used anywhere else.
-For more information on how to use and in-
stall the Pick Up car seat, please contact your
local distributor or retailer.
15