Beurer MG 160 Instrucciones Para El Uso página 12

WARNING
• Do not subject the device to any impact and do not drop it.
• Do not use the device if damage is evident to the device itself or any of itsaccessories.
• The massage device must only be operated with the supplied power supply unit, which
must be connected to a power supply with the mains voltage indicated on the power supply unit.
• Route the cable safely so that there is no risk of anyone tripping over it.
• Connect your device to the mains by plugging the power supply unit into the mains outlet.
6. Operation
• Sit comfortably on the seat cover. Take care that you sit centered and your body is in good even contact
with the seat cover.
• Switch on the massage device with the ON/OFF button. The massage intensity is preset to level 1.
• Press the PROGRAM button or at least one of the MASSAGE ZONES buttons to start the massage.
• If you wish to have a long massage with individual massage zones or all of them, select the massage zones
with their respective buttons. The massage zones activated are displayed with the LEDs.
• The automatic switch-off function is activated by starting the massage and is preset to 20 minutes. You
can set the automatic switch-off function to 10, 20 or 30 minutes by pressing the TIMER button.
Please note that changing the timer setting makes the timer start to count again from the beginning. To
avoid overheating the device, select the maximum massage duration at the beginning of the massage and
do not change it again during the massage.
• If you would like a massage with one of the various programs, select the required program with the
PROGRAM button. The 5 massage programs are characterized by different sequences of massage zones
and massage intensities.
• Press the INTENSITY button to select of the 3 possible massage intensities.
• Press the HEAT button to switch the heat function in the lumbar region on and off.
• Do not use the massage device for longer than 30 minutes. The massage can be finished at any time by
pressing the ON/OFF button.
• After the massage is finished, connect the power supply unit plug from the mains.
Note
• You can place the hand switch in the storage case during and after use.
• Always wear light clothing when receiving a massage from the device.
• Do not use the massage device for longer than 15 minutes. Otherwise, using the device for longer
can over-stimulate the muscles and cause tension instead of relaxation.
• Do not use the massage device just before going to bed. The massage can also have a stimulating
effect and may cause difficulties in getting off to sleep.
WARNING
The massage must be pleasant and relaxing at all times. Stop the massage or change your position
or the contact pressure if you find it is painful or unpleasant.
Alternative use in the car
The massage seat cover can also be used in the car with the car adapter supplied. Plug the car adapter
connector plug into the connection jack on the device. Plug the car adapter into the cigarette lighter jack or
an alternative 12 V jack. (e.g. trunk). Operation proceeds as described above.
WARNING
Never have a massage with the massage seat cover while you are driving a car yourself. The
massage, as well as the device setting, distracts you from the road traffic. Your attention to the road
traffic must never be impaired by the device. Therefore only use this device as a passenger or if you
take a break and the vehicle is stationary. Please note that if the engine is off the battery can discharge
under certain circumstance. For some vehicles the 12 V jack only works when the engine is on.
A massage with this seat cover can be very relaxing and regenerating while taking breaks.
12