– remove the upper front (4) and
lower front (6) panels;
– remove the rear panels (8), (9) and
(10) by unscrewing the screws
securing them to the sides;
– disassemble the left side (7) by
removing the bolt securing it to the
bracket, then sliding outward to
uncouple it from the rollers on the
boiler bracket;
– follow the same procedure to
remove the right side (2).
3.4
MAGNESIUM ANODE
The magnesium anode (11 fig. 2) pro-
tects the boiler from galvanic currents;
the durability of the anode will depend
on the quality of the local water supply.
Check the magnesium anode peri-
odically; replace when exhausted.
Failure
to
renew
anodes will render the guarantee
null and void.
26
The anode is fitted to the front of the
boiler for easy access.
3.5
CLEANING THE BOILER
The boiler body and flue should be
cleaned at the end of each season.
The baffles (2 fig. 9) must be removed
before cleaning operations.
Once maintenance has been complet-
ed, reposition the baffles.
Use the pig (1 fig. 9) to clean the
smoke pipes.
NOTE: Preventive maintenance must
be carried out by authorised techni-
cal staff.
3.6
USER WARNINGS
exhausted
When faults occur and/or the equip-
ment does not operate correctly, turn
it off, without attempting to make any
repairs or take direct action.
For any operation only contact the
authorised technical personnel in your
area.
Fig. 9