Start Up; Anti-Static System; Dry Vacuum Cleaning; Insert And Lock The Suction Head - Flex VCE 45 M AC Manual Del Usuario

The appliance allows 2 operating modes:
1 Industry vacuum cleaner mode (socket
not used)
2 Dedusting mode (socket used)
 Connect the suction hose and insert the
suction nozzle or connect to the dust-
generating device depending on the op-
erating mode.
WARNING
The flat pleated filter must always be in
place while vacuuming.
WARNING
Do not vacuum without the filter elements;
otherwise, the suction motor can get dam-
aged and this can be hazardous to health
on account of increased release of fine dust
particles.
The horn blows when the air speed falls be-
low 20 m/s.
Note: The horn reacts to negative pres-
sure.
 Set the rotary switch to the correct suc-
tion hose cross-section.

Anti-static system

Static charge is deflected by providing
earthing to the connection nozzles. This
prevents the formation of sparks and cur-
rent shocks due to attachments (option)
with electrical conductivity.

Dry vacuum cleaning

– The appliance is equipped with a paper
filter bag with a locking slide, order no.
340.758 (5 pcs).
– The appliance is equipped with a dis-
posal bag with locking slide and locking
strip, order no. 340.766 (10 pc).
Note: You can use this appliance to take up
all types of dust up to dust class M. It is stat-
utorily necessary to use a dust collection
bag (see Filter systems for order number).
18

Start up

Horn
Note: The appliance is suited as industrial
vacuum cleaner and as dedusting device
for the mobile operation to take up dry, non-
combustible dusts with MAK values greater
than or equal to 0.1 mg/m
– When vacuuming up fine dust, a paper
filter bag or a disposal bag must addi-
tionally be used.
Installing the paper filter bag
Illustration
 Release and remove the suction head.
 Fit the paper filter bag.
 Insert and lock the suction head.
Install disposal bag
Illustration
Note: The opening of the disposal bag
must completely be pulled over the shoul-
der of the suction nozzle.
 Release and remove the suction head.
 Mount the disposal bag.
 Place the disposal bag over the con-
tainer.
 Insert and lock the suction head.
Changeover from wet to dry vacuum
cleaning
Only applies when a flat fold filter with the
order no. 337.692 is used:
ATTENTION
Please note the following when switch-
ing from wet to dry vacuum cleaning:
If you vacuum dry dust while the filter ele-
ment is still wet the filter will become ob-
structed and may be damaged beyond re-
pair.
 Replace wet filter with a dry one prior to
use.
 Change the filter, if required, according
to instructions under the section "Main-
tenance and Care".
Note: For permanent wet vacuum cleaning
it is advisable to use a PES flat pleated filter
(see filter systems).
– 3
EN
.
3