Operation; Close The Suction Connection; Pull The Paper Filter Bag Out Towards The; Pull Up The Locking Slide And Tightly - Flex VCE 45 M AC Manual Del Usuario

Wet vacuum cleaning
DANGER
No dusts hazardous to health should be
sucked in during wet vacuuming.

Close the suction connection

Illustration
 Properly insert the connection socket in
the suction connection.
 Push in the connection socket until it
locks into place.
 Turn the suction connection with the
connection socket to the right to close it
tightly.
Note: The accurate fit is ensured by means
of a "bayonet connection".
Removing the paper filter bag
Illustration
 Release and remove the suction head.
 Pull the paper filter bag out towards the
back.
 Pull up the locking slide and tightly

close the paper filter bag upon removal.

 Dispose of the used paper filter bag in

the closed, dust-proof bag in accord-

ance with legal requirements.

 Insert and lock the suction head.
– When vacuuming up wet dirt, the paper
filter bag must always be removed.
Removing the disposal bag
Illustration
 Release and remove the suction head.
 Pull the disposal bag up.
 Pull the opening of the disposal bag out

toward the back over the suction sup-

port and seal it tightly.

 Tightly seal the disposal bag with clo-

sure strips underneath the opening.

 Remove the disposal bag.
 Dispose of the used disposal bag ac-

cording to the local provisions.

 Insert and lock the suction head.
– To vacuum wet dirt, always remove the
disposal bag.
General
– If wet dirt is vacuumed with the uphol-
stery or crevice nozzle (option) or if wa-
ter is sucked up from a container it is
recommended to deactivate the "auto-
matic filter dedusting" function.
– If the maximum liquid level is reached
the appliance will turn off automatically.
– In case of non-conductive liquids
(such as emulsion drilling fluids,
oils, and greases) the appliance is
not turned off when the container is
full. The filling level must be continu-
ously monitored and the container
must be emptied in time.
– After completion of the wet vacuuming:
Clean the flat pleated filter using the fil-
ter dedusting unit and allow the filter to
dry sufficiently. Clean the electrodes
using a brush. Clean the container with
a damp rag and dry it.
Clip connection
Illustration
The suction hose is equipped with a clip
system. All C-35/C-DN-35 accessories can
be connected.
Turning on the Appliance
 Plug in the mains plug.
 Switch on the appliance at the main
switch.
Adjust the suction output
 Set the suction output (min - max) at the
rotary switch.
– 4
EN

Operation

19