Safety Indications; Symbols - Gaggia Ruby Manual De Instrucciones

1.

Safety Indications

1.1 Symbols

WARNING
!
May cause injuries.
INFORMATION
i
Important or useful information.
RISK OF FIRE OR ELECTRIC SHOCK
May cause injuries
We ask you to carefully read this instruction manual before operating your new coffee machine for the first time.
Keep these instructions in a safe place where you can consult them when necessary.
The inappropriate use of this machine exempts Quality Espresso from any liability.
1.2 Safety Indications
Installation
Transport
Storage
Placement
Electrical
Connection
 The machine should only be installed by authorized technical personnel. The manufacturer
declines any liability for possible injuries caused by inappropriate installation.
 The use of gloves and a minimum of two people is recommended to manually move the machine
to its installation site.
The machine should be stored in areas with a temperature higher than 5º C.

In the event of storage or transport of the machine in temperatures lower than 0º C, and in order to

prevent freezing, the machine's hydraulic circuit should be emptied first.
In the event of freezing, the machine should be placed in an area with a temperature higher than

10º C to wait for unfreezing. Under no circumstances should the machine be connected to the
electrical circuit before it is unfrozen.
 It is recommended that the machine be installed in a spacious area, free of air currents and with a
solid base. Avoid installing the machine on a wet or hot surface.
 Regulate the height of the machine with the support legs. Maximum inclination cannot be greater
than 1º between any of its axes.
Check that all of the electrical connection characteristics comply with the voltage, frequency and

wattage indications described on the machine's specification plate. This plate is located on the
chassis under the drainage tray.
 We consider the machine to be installed correctly when it has been connected to a magneto-
thermic omnipolar circuit breaker appropriate to the machine's power, along with a differential that
does not exceed a residual current of 30 mA.
 The machine must be installed in accordance with the current electrical regulations of your area.
You must make ensure that the electrical installation is reliably grounded in accordance with the
aforementioned regulations. The company declines any liability for possible injuries caused by a
defective installation or incorrect ground connection.
Extension cords or outlet adapters of any kind should not be used to connect the machine to the

power supply. The connection cable should never be rolled up, but instead it should be fully
extended to avoid possible overheating.
16
13