Important Features; Remote Control; Inserting Batteries - Revell Control BIG GLOW Manual Del Usuario

23983

IMPOrTaNT FeaTUreS

Micro helicopter:
• New coaxial rotor system with electronic
gyro for outstanding flying properties
• Sturdy plastic hull
• Integrated rechargeable LiPo battery
(Lithium Polymer battery)
Safety instructions:
• This helicopter is only suitable for use
indoors and not for use outdoors.
• This helicopter is suitable for pilots who
are at least 15 years of age. Adult
supervision is required when flying it.
• Keep your hands, face, hair and loose
clothing away from the rotor.
• Switch off the remote control and
helicopter when they are not in use.
• Remove the batteries from the remote
control when it is not in use.
• Always maintain visual contact with the
helicopter in order to avoid losing
control of it.
• We recommend new alkali manganese
batteries for the remote control.
• As soon as the remote control no
longer functions reliably, new batteries
should be inserted.
• Please keep this operating manual safe
for later use.
• The user should only operate this
helicopter in accordance with the
instructions for use in this operating
manual.
• Do not fly the helicopter near people,
animals, bodies of water or power lines.
• The charging unit for the LiPo battery is
specially designed for charging the
helicopter battery. The charging unit
may only be used to charge the
helicopter battery, not other batteries.
12
• Integrated rechargeable LiPo
battery (Lithium Polymer battery)
• With self-illuminating canopy
Maintenance and care:
• Please only use a clean, damp cloth
to wipe off the helicopter.
• Protect the helicopter and batteries
from direct sunlight and/or direct
heat.
• Never allow the helicopter to come
into contact with water. This may
result in its electronics becoming
damaged.
Remote control battery safety
instructions:
• Non-rechargeable batteries may not
be charged.
• Rechargeable batteries must be
removed from the remote control
prior to recharging.
• Rechargeable batteries may only
be charged under the supervision
of an adult.
• The combination of different types
of batteries as well as new and
used batteries must be avoided.
• Only recommended batteries or those
of an equivalent type may be used.
• Single-use batteries for this remote
control and other electrical devices
operated in the home can be
replaced with environmentally-
friendly rechargeable batteries.
• Batteries must be inserted according
to the correct polarity (+ and -).
• Depleted batteries must be
removed from the remote control.
• The connection terminals may not
be short-circuited. Please remove
the batteries from the remote
control if it is not to be used for
an extended period of time.
The helicopter is equipped with
a rechargeable lithium polymer
battery. Please observe the
following safety instructions:
• Never throw LiPo batteries into a
fire or store them in a hot location.
• Only use the charger integrated in
the remote control for charging.
• When disposing of batteries, they
must be discharged or their
capacity must be fully depleted.
Cover exposed terminals with
adhesive tape in order to prevent
short-circuiting!
Safety instructions:
• The product may never be
structurally modified. This may
lead to it becoming damaged
or posing a danger.
• Avoid the risk of danger by never
operating the aircraft while sitting
on the ground or in a chair.
Operate the aircraft from a position
that allows easy evasion if needed.
• Always switch off the aircraft and
the remote control after use.
Otherwise, it is possible for the
model to be unintentionally
started.
Required batteries for the heli-
copter:
Power supply: ===
Batteries: 1 x 3.7 V rechargeable
LiPo battery (integrated)
Capacity: 500 mAh; 1.85 Wh
Charger:
Power supply:
AC 240 V; 50 Hz
Rated output: 6 V / 600 mA
Battery requirement for the

remote control:

Power supply: ===
DC 6 V
Batteries: 4 x 1.5 V "AA"
(not supplied)
1 helICOPTer
1A Stabiliser 1D Landing skid
1B Counter-rotating 1E Tail rotor
rotor blades
1F ON/OFF switch
1C Search
1G Charge socket
headlamp
2 reMOTe CONTrOl
2A Power LED 2D Power ON/OFF
2B Controller for 2E Up/down thrust
forward/reverse controller
and flying
left/right
2C Left/right trim
knob

3 INSerTINg BaTTerIeS

(reMOTe CONTrOl)
3A Unscrew and remove the cover.
3B Insert 4 x 1.5 V AA batteries and pay
attention to the polarity, as shown in
the battery compartment.
3C Close the battery cover and secure
with the screw.
13