Electrical Connection; Complete The Installation - ELICA EVI642S1 Guía De Instalación, Uso Y Mantenimiento

Electrical Connection

I WARNING
ELECTRICAL SHOCK HAZARD.
I WARNING
DISCONNECT POWER BEFORE SERVICING.
REPLACE ALL PARTS AND PANELS BEFORE OPERATING.
FAILURE TO DO SO CAN RESULT IN DEATH OR
ELECTRICAL SHOCK.
1 Disconnect power.
2 Remove terminal box cover.
3
Remove the knockout in the terminal box cover and install
a UL listed or CSA approved
B
C
B.
C. Junction box cover screws
4 Run home power supply cable through strain relief, into
terminal box.
D
A. Home power supply cable
B. UL listed or CSA approved
strain relief
C. Black wires
2 Use UL listed wire connectors and connect black wires
(B) together.
3 Use UL listed wire connectors and connect white wires (A)
together.
10
⁄ " strain relief.
1
2
A
A. Knockout
Junction box cover
B
A
E
D
C
D. UL listed wire connectors
E. White wires
F. Green (or bare) and
yellow-green ground wires
I WARNING
ELECTRICALLY GROUND BLOWER.
CONNECT GROUND WIRE TO GREEN AND YELLOW
GROUND WIRE IN TERMINAL BOX. FAILURE TO DO SO
CAN RESULT IN DEATH OR ELECTRICAL SHOCK.
4 Connect green (or bare) ground wire from home power
supply to yellow-green ground wire (D) in terminal box
using UL listed wire connectors.
5 Tighten strain relief screw.
6 Install terminal box cover.
7
Check that all light bulbs are secure in their sockets.
8
Reconnect power.

Complete the Installation

Duct cover installation
• Attach the upper duct covers using the installation screws
shown in the figure.
A. Upper duct covers
B. 4 - 3.5x6.5 mm installation screws
C. 2 - 2.9x3 mm screws
B
A
C