Publicidad
Specifi cations
Power management
This monitor conforms to VESA DPMS and DVI DMPM. Both your video card and computer must support
the same standard in order for the monitor's power management function to work.
DPMS: Display Power Management Signaling
DPMS
Screen
Power consumption Hsync Vsync
312 W (TL-M5200)
ON STATE Display
278 W (TL-M4600)
No
1.7 W* (at AC 120 V)
STANDBY
display
2.0 W* (at AC 240 V)
DDC (plug and play)
The monitor supports the VESA DDC (Display Data Channel) standard.
DDC is a signal standard for plug and play between monitors and computers. Information about resolution
and other parameters is exchanged between the two. This function can be used if the computer supports
DDC and it has been configured to detect plug-and-play monitors.
There are several types of DDC, depending on the communication method used. This monitor supports
DDC2B.
Connecting pin assignments
DVI-D input terminal: DVI-D 24 pin
RS-232C terminal: D-sub 9 pin
50
DMPM: Digital Monitor Power Management
DMPM
Monitor ON
Yes
Yes
Active OFF
No
No
* When "Standby Mode" is set to "Mode2".
33 W when "Standby Mode" is set to "Mode1".
(TL-M5200)
30 W when "Standby Mode" is set to "Mode1".
(TL-M4600)
Pin No.
Signal
1
T.M.D.S data 2-
2
T.M.D.S data 2+
3
T.M.D.S data 2/4 shield
4
Not connected
5
Not connected
6
DDC clock
7
DDC data
8
Not connected
9
T.M.D.S data 1-
10
T.M.D.S data 1+
11
T.M.D.S data 1/3 shield
12
Not connected
Pin No.
Signal
1
Not connected
2
Received data
3
Transmitted data
4
Not connected
5
GND
Screen
Power consumption
312 W (TL-M5200)
Display
278 W (TL-M4600)
1.9 W* (at AC 120 V)
No display
2.1 W* (at AC 240 V)
Pin No.
Signal
13
Not connected
14
+5 V power
15
GND
16
Hot plug detection
17
T.M.D.S data 0-
18
T.M.D.S data 0+
19
T.M.D.S data 0/5 shield
20
Not connected
21
Not connected
22
T.M.D.S clock shield
23
T.M.D.S clock+
24
T.M.D.S clock-
Pin No.
Signal
6
Not connected
7
Request to Send
8
Clear to Send
9
Not connected
Publicidad
Capítulos
