Battery Test - GYS STARTIUM 330E Manual Del Usuario

Translation of the original instructions
Start and charge a battery in-situ :
In the event that the negative terminal is plugged onto the car's chassis :
Connect the red clamp to the battery's positive terminal.
1.
2. Connect the black clamp to the vehicle's chassis, make sure it is a safe distance from the battery and the
fuel/exhaust pipe.
Connect the device to the mains.
3.
4. Choose the user mode, charge speed and switch the STARTIUM on.
5. After use, set the switch to OFF, disconnect the charger from the mains then remove the black clamp,
followed by the red clamp.
Some vehicles have the positive terminal plugged onto the car chassis, in this event :
Connect the black clamp to the battery's negative terminal.
1.
2. Connect the red clamp to the vehicle's chassis, make sure it is a safe distance from the battery and the
fuel/exhaust pipe.
Connect the device to the mains.
3.
Choose the user mode, charge speed and switch the STARTIUM on.
4.
5. After use, set the switch to OFF, disconnect the charger from the mains then remove the red clamp first
and the black clamp last.
Charging a battery when disconnected from the vehicle :
1. Connect the red clamp to the battery's positive terminal and the black clamp to the battery's negative
terminal.
Connect the device to the mains.
2.
4. Choose the user mode, charge speed and switch the STARTIUM on.
3. After use, set the switch to OFF, disconnect the charger from the mains then remove the red clamp first
and the black clamp last.
USE IN CHARGER MODE
12V
Charging
capacity
24V
◊ Preliminary precautions
• Choose a sheltered and well ventilated area, or a dedicated battery charging area.
• Remove the battery caps (if applicable) and make sure that the liquid or gel level (electrolyte) is sufficient. If not,
add demineralised water and carefully clean the battery lugs and terminals.
• Check that the battery capacity (Ampere hour Ah) and the voltage (Volt V)are compatible with your charger (see
table above).

◊ Battery test

Before peforming a charge, it is possible to test the battery level. Connect the red clamp connector on «12V» or «24V»
depending on the voltage indicated on the battery. The display indicates the battery's state of health. It alternates
between the actual voltage and the state of charge percentage. A 12V battery is at a 100% capacity if its voltage is
superior to 12.8V. It is at 0% if its voltage is inferior to 11.8V. A 24V battery is at a 100% capacity if its voltage is superior
to 25.6V. It is at 0% if its voltage is inferior to 23.6V.
◊ Charge (cf. interface, p.5)
Once the charger is connected to the battery while following the recommended procedure (see chapter. connection and
disconnection), plug the red clamp's connector on the voltage : «12V» or «24V». Select the charge speed (p.4, n°13)
with respect to the battery capacity (see table below), choose the battery type (n°12) then briefly press the START/
STOP button (n°9). To stop the charge at any time, press the START/STOP button.
◊ UNIVERSAL MODE
16
In the event that the battery type is unknown (Liquid, Gel, AGM, Start/Stop), select the UNIVERSAL mode.
STARTIUM 330E / 480E / 680E / 980E
STARTIUM 330E STARTIUM 480E
20 - 375 Ah
20 - 300 Ah
STARTIUM 680E
20 - 600 Ah 20 - 675 Ah
20 - 450 Ah 20 - 525 Ah
EN
STARTIUM 980E
20 - 750 Ah
20 - 525 Ah