Data Transmission; Search For Sensor; Clock; Turn Clock On / Off - Oregon Scientific BAR636 Manual Del Usuario

For best results:
• Insert the batteries and select the channel before you
mount the sensor.
• Place the sensor out of direct sunlight and moisture.
• Do not place the sensor more than 30 metres (98
feet) from the main (indoor) unit.
• Position the sensor so that it faces the main (indoor)
unit, minimizing obstructions such as doors, walls,
and furniture.
• Place the sensor in a location with a clear view to the
sky, away from metallic or electronic objects.
• Position the sensor close to the main unit during cold
winter months as below-freezing temperatures may
affect battery performance and signal transmission.
You may need to experiment with various locations to
get the best results.

DATA TRANSMISSION

Data is sent from the sensor(s) every 40 seconds. The
reception icon shown in the Temperature Area shows
the status.
ICON
--- shows in Outdoor
Temp Area

SEARCH FOR SENSOR

To search for a sensor, press and hold MEMORY and
CHANNEL (on the main unit) for 2 seconds.
NOTE If the sensor is still not found, check the batter-
ies, obstructions, and remote unit location.
NOTE Signals from household devices such as door-
bells, electronic garage doors, and home security sys-
tems may cause temporary reception failure. This is
normal and does not affect general product performance.
The reception will resume once the interference ends.
DESCRIPTION
Main unit is searching for
sensors.
At least 1 Channel has been
found.
Channel 1 is selected
(number will change
depending on the sensor
you select).
The selected sensor cannot
be found. Search for the
sensor or check batteries.

CLOCK

The clock automatically synchronizes the current time
and date when it is brought within range of the radio
signal DCF77 generated from Frankfurt, Germany for
Central Europe (model BAR636) or MSF60 generated
from Rugby, England (model BAR636U).
NOTE The signals are collected by the main unit when
it is within 1500 km (932 miles) of a signal.
Initial reception takes 2-10 minutes, and is initiated when
you first setup the unit, and whenever you press RESET.
Once complete, the reception icon will stop blinking. The
icon is shown in the Clock Area.
STRONG SIGNAL WEAK SIGNAL
To force a manual search for clock signals, press and
hold for 2 seconds. If no signal is found, check the
batteries.

TURN CLOCK ON / OFF

Perform this step if you cannot receive clock signals.
Press and hold for 2 seconds. Then, manually set
the clock following the "Set Clock" instructions (below).
The signal icon indicates that the clock feature is
ON. No icon means that it is OFF.

SET CLOCK / CALENDAR

You only need to do this if you have disabled the RF
clock feature (for example, if you are too far from or
cannot receive a signal).
1. Press and hold MODE for 2 seconds. The Clock Area
will blink.
2. Select the hour, minute, year, month, day, and day
of the week language. Press
the setting.
3. Press MODE to confirm.
The language options are (E) English, (F) French, (D)
German, (I) Italian, and (S) Spanish.

SWITCH CLOCK DISPLAY

Press MODE to toggle between Clock with Seconds and
Clock with Weekday display.
5
NO SIGNAL
or to change