Printing A Network Setup Page; Printing Quick Reference Information - Lexmark C510 Manual De Instrucciones

Note:
When you add or
remove these options:
530-sheet tray, duplex unit,
printer or flash memory, or
firmware card, remember to
update the printer
configuration through your
printer driver.
Printing a network
setup page
Note:
If an optional
MarkNet™ print server is
installed, you may see
Print Net1 Setup (or
Print Net2 Setup).
Printing Quick
Reference
information
If an option you installed is not listed, turn the printer off, unplug
the power cord, and reinstall the option. See Step 6: "Install
memory, firmware, or option cards" on page 22 for more
information.
5
Verify the amount of memory installed is correctly listed under
"Printer Information."
6
Verify that the paper trays are configured for the sizes and types
of paper you loaded.
If the printer is attached to a network, print a network setup page to
verify the network connection. This page also provides important
information that helps you configure for network printing.
Save the network setup page after it prints. You will use it in the later
steps.
1
Make sure the printer is on.
2
Press Menu until you see UTILITIES MENU, and then press
Select.
3
Press Menu until you see Print Net Setup, and then press
Select to print the page.
4
Check the first section on the network setup page and confirm
that Status is "Connected."
If Status is "Not Connected," your LAN drop may not be active
or your network cable may be malfunctioning. Consult your
network administrator for a solution. Afterwards, print another
network setup page to verify connection to your network.
Information about using the printer and clearing jams is included on
the publications CD that shipped with your printer documentation.
We recommend you print this information and store it in a convenient
location near the printer.
To print Quick Reference information stored on the CD:
1
Launch the CD.
2
Click Quick Reference.
Verify printer setup
45