Conceptronic CM3H Manual Del Usuario página 22

ENGLISH
• Select the correct input channel on your TV where the unit is connected to. (HDMI, Composite, SCART or
Component).
Note: From this point, the manual is based on the fact that your TV is set to the input channel of the
unit. All steps described are related to the operation of the unit.
• Check if the main power switch on the back of the unit is set to 'I'.
• Turn on the unit with the Play/Stop button on the front of the unit, or with the 'Power' button (1) on
the remote control.
The unit will turn on and display the menu on your screen.
Note: The default output signal of the unit is Composite Video. If the unit is turned on and nothing is
shown on your screen, you can press the 'Output' button (19) on the remote control to switch
between the various outputs of the CM3H (HDMI, Composite, Component).
Note: The unit needs to initialize the hard disk when it is turned on. This can take a little while. During
initializing, the message 'LOADING...' is shown on your screen.
When the hard disk is formatted with 1 partition, it will show the 'File List' on your screen, displaying the
contents of your hard disk.
When the hard disk is formatted with multiple partitions, the unit will show the 'Partition List' on your
screen with all the present partitions. Use
' /Enter' (24) button to go to the 'File List', showing the contents of the selected partition.
[ Parition List ]
Change the partition:
When the hard disk is formatted with multiple partitions, you can press the 'Menu' (38) button on the
remote control to go to back to the 'Partition List' and select a different partition.
7. Basic CM3H operation
/ buttons (15) to move the selection, and press the
22
[ File List ]