DANA Spicer 360A10 Manual De Servicio página 38

ASSEMBLING THE REDUCTION GEAR - ASSEMBLAGGIO RIDUTTORE - REDUZIERER ZUSAMMENBAUEN - ASEMBLAJE REDUCTOR -
GB
Position the flow guard (21) and ensure that it is properly engaged
in its seat.
19
GB
Insert guide bushings (19) and apply Loctite 510 to the coupling
surface of the casing.
Check position of guard (21) and fit cover (18).
24
GB
Using an appropriate driver, fit the bearing (24) in the cover (18).
ASSEMBLAGE REDUCTEUR
21
DNF00550
a
18
21
19
DNF00570
c
18
DNF00590
e
38
20
GB
Fit the output shaft (20) in the reduction gear body (52) and engage
shaft by hitting with a plastic hammer.
GB
Block cover (18) with screws (55) and spring washers (56). Tighten
all screws (55), and then torque them to 50 Nm using the alternate
and criss-cross methods. Start tightening with central screws.
Apply Loctite 510 to the previously removed stud (17) and screw it
down in the cover (18).
15
GB
Coat the surface of lid (15) and screw (13) with Loctite 510 and
install lid (15), locking it with screws and relative spring washers
(14).
Tighten screws to a torque of 50 Nm using the criss-cross method.
52
DNF00560
b
18
55 56
DNF00580
d
DNF00600
f