Specifications - Sony VPL-HS2 Manual De Instrucciones

4 Insert the new air filter into the filter holder
with the white surface up, put the holder
face down, then replace it into the
projector.
5 Replace the filter cover.
6 While pushing the projector cover toward
you by holding both sides of the cover on
the lens side, close the cover until it clicks.

Specifications

System
Projection system
3 LCD panels, 1 lens, projection
system
LCD panel 0.62-inch TFT LCD panel, 1,245,816
pixels (415,272 pixels × 3)
Lens 1.2 times zoom lens (manual)
f33.6–42mm/F1.85–2.2
Lamp 150 W UHP type
Projection picture size
Range: 40 to 150 inches (measured
diagonally)
Color system NTSC
3.58
PAL-M/PAL-N system, switched
automatically/manually
Acceptable video signals
15 kHz RGB/component 50/60 Hz,
Progressive component 50/60 Hz,
DTV (480/60i, 575/50i, 480/60p,
575/50p, 720/60p, 720/50p, 1080/
60i, 1080/50i), 1080/24PsF,
Composite video, Y/C video
Acceptable computer signals
fH: 19 to 72 kHz
fV: 48 to 92 Hz
Maximum resolution XGA 1024
768, fV: 85 Hz
Speaker Monaural speaker system, 33 mm
5
(1 /
16
max. 2 W
Input
Video input VIDEO: phono type
Composite video: 1 Vp-p±2 dB
sync negative (75 ohms terminated)
S VIDEO: Y/C, mini DIN 4-pin type
(male)
Y (luminance): 1 Vp-p±2 dB sync
negative (75 ohms terminated)
C (chrominance): burst 0.286 Vp-p
±2 dB (NTSC)
(75 ohms terminated)
burst 0.3 Vp-p±2 dB (PAL)
(75 ohms terminated)
PJ MULTI 32-pin multi connector
Composite video: 1 Vp-p±2 dB sync
negative (75 ohms terminated)
S video: Y/C
Y (luminance): 1 Vp-p±2 dB sync
negative (75 ohms terminated)
/PAL/SECAM/NTSC /
4.43
×
inches) diameter,
×
1
Specifications
33
GB