Incorrect Operation - Yale TIGRIP Manual Del Usuario

12
Two-legged lifting gear is only suitable for small plates with low weights, for which sway during
transport can be compensated by hand. When attaching the load lifting attachment, it must be
ensured that the centre of gravity of the load is in the middle between the load lifting
attachments so that no inclined position is caused. The load lifting attachment must be
arranged on the load in such a way that the inclination angle of the load lifting attachment
does not exceed 30° in the direction of the mouth opening and 45° in the opposite direction.
max. 30° max. 30° max. 30° max. 30°
Always transport the load slowly, carefully and close to the ground.
Make sure that when depositing the load, the crane hook does not press against the load
lifting attachment. The weight of the crane hook could lead to opening of the load lifting
attachment.
Only use crane hooks with a safety latch.
The suspension eye of the load lifting attachment must have sufficient space in the crane hook
and be freely articulating.
In the case of malfunctions, stop using the load lifting attachment immediately.
I O
NCORRECT PERATION
(list not complete)
Do not exceed the rated load capacity (WLL) of the unit.
Only loads within the specified jaw capacity must be picked up.
The load must never be less than the min. load, as otherwise the clamping force required for
safe transport will not be reached.
Any modifications of the load lifting attachment are prohibited.
It is forbidden to use the load lifting attachment for the transportation of persons.
When transporting loads ensure that the load does not swing or come into contact with other
objects.
©
2016 Columbus McKinnon Industrial Products GmbH