Data Protection; Guarantee And Liability - Würth ACCTIVA EASY Manual De Instrucciones

EMC and EMF
measures

Data protection

Guarantee and
liability
Disposal
Safety
Copyright
It is the operator's responsibility to ensure that no electromagnetic interference
occurs in electrical and electronic devices.
EMC device classification (see rating plate or technical data)
Class B devices satisfy the requirements of the electromagnetic compatibility
directive in industrial and residential areas. This also applies to residential areas
where the power supply is provided by the public low-voltage network. Class A
devices can cause mains-borne and radiated interference in residential areas. If
this happens, the operator may be required to take appropriate measures.
The user is responsible for the safekeeping of any changes made to the
factory settings. The manufacturer accepts no liability for any deleted perso-
nal settings.
We provide a warranty for this Würth charger in accordance with legal/
country-specific regulations from the date of purchase (proof of purchase
necessary). Any damage will be rectified by replacement or repair.
Damage caused by normal wear and tear, overloading or improper use is not
covered by the guarantee.
Claims will only be acknowledged if the charger is handed over intact to a
Würth subsidiary, sales representative or Würth authorised customer service
center for electrical equipment.
Do not dispose of this device with normal domestic waste!
To comply with the European Directive 2002/96/EC on Waste Electrical and
Electronic Equipment and its implementation as national law, electrical
equipment that has reached the end of its life must be collected separately
and returned to an approved recycling facility Any device that you no longer
require must be returned to our agent, or find out about the approved collec-
tion and recycling facilities in your area.
Ignoring this European Directive may have potentially adverse affects on the
environment and your health!
We declare under our sole responsibility that this product is in conformity
with the following standards or normative documents: EN 60335-1:2002, EN
60335-2-29:2004, EN 61000-6-3:2007, EN 61000-6-1:2007, EN 62233:2007
according to the provisions of Directives 2006/95/EG, 2004/108/EG.
Würth International AG
Copyright of these operating instructions remains with the manufacturer.
Text and illustrations were accurate at the time of printing. Subject to change
without notice. The content of the operating instructions does not justify any
claims that may be made by the purchaser. We are grateful for any suggesti-
ons for improvement and for drawing our attention to any errors in these
instructions.
IV