ELICA OM AIR NATURE/F/75 Montaje Y Modo De Empleo página 20

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 34
Operation
Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the cooker hood suction is
switched on for 5 minutes prior to cooking and to leave in
operation during cooking and for another 15 minutes
approximately after terminating cooking.
To select the functions of the hood just touch the commands.
Light key ON/OFF
Intensive speed selection key (suction
power) - duration 5 minutes - press again to
return to previous setting.
High-speed selection key (suction power).
Medium-speed selection key (suction power)
- when flashing it indicates the need to wash or
replace the carbon filter. This signal is normally
deactivated. To activate the alarm, disable the
electronic by pressing the 0 button for 3
seconds.
Next, simultaneously press buttons 1 and 2 for
3 seconds; at first, only button 1 will flash, then
both buttons 1 and 2 will flash to indicate
activation. Repeat the procedure to deactivate
the alarm; at first buttons 1 and 2 will flash and
subsequently only button 1 to indicate
deactivation.
Low-speed selection key (suction power) –
when flashing it indicates the need to wash the
fats filter.
Motor key OFF (stand by) – excludes the
electronics – reset wash/replace filters signals.
MOTOR OFF
Press briefly to switch the motor off.
RESET FILTERS SIGNALS
In functioning mode, after carrying out filter
maintenance, press the key until hearing the
sound signal. The flashing LED 1 (grease filter)
or 2 (carbon filter) stops flashing.
EXCLUDING THE ELECTRONICS
Press the key for 3 seconds. The hood
command electronics will be excluded.
This function can be useful during the product
cleaning operations.
Just repeat the operation to reinsert the
electronics.
If the hood fails to operate correctly, briefly disconnect it from
the mains power supply for almost 5 sec. by pulling out the
plug. Then plug it in again and try once more before
contacting the Technical Assistance Service.
Note: with the hood ON, the outer ring of the hood retreats
("open" position) to allow the passage of air.
Turning off the hood 'the ring returns to rest position ("closed"
position).
Note: The perimeter suction panel should always be left
closed and should only be opened when maintenance is
performed.
A special device prevents accidental movement of the outer
ring with the perimeter suction panel open.
Cleaning mode:
Exclude electronic components (see "EXCLUDING THE
ELECTRONICS " in the previous paragraph..
Press
and
indicate that you are in "Cleaning mode" and it is therefore
possible to perform filters' maintenance or access the motor
compartment.
Press the button
mode" function.
20
for 3 seconds, buttons start flashing to
for 3 seconds to exit the "Cleaning

Publicidad

Tabla de contenido
loading

Tabla de contenido