General Description - GYS GYSFLASH HERITAGE 6 A Manual Del Usuario

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

  • ESPAÑOL, página 14
Maintenance:
• If the power cable is damaged, it must be replaced by the
manufacturer, its after sales service or an equally qualified person
to prevent danger.
Regulations:
• Machine compliant with European directives.
• The certificate of compliance is available on our website.
• EAC Conformity marking (Eurasian Economic Community)
Waste management:
• This product should be disposed of at an appropriate recycling
facility. Do not throw away in a domestic bin.

GENERAL DESCRIPTION

Your Gysflash is ideal to charge most lead-acid batteries, often used for cars and many other vehicles. The GYSFLASH can be used
safely for : GEL (gel electrolyte), AGM (Absorbant Glass Mat), EFB ( Enhanced Flooded Battery), WET, MF (Maintenance Free), CA
(Calcium)...
The Gysflash Heritage 6A is designed to charge :
- 6V batteries (3*2V elements) from 1.2Ah to 125Ah and yo to 170Ah for maintenance charge,
- 12V batteries (6*2V elements) from 1,2Ah to 125Ah and up to 170Ah for maintenance charge.
START UP
1. Connect the charger to the battery using the proper accessory (clamps, lugs, etc...).
2. Plug the charger to the mains (single phase 220-240Vac 50-60Hz).
3. Select the mode by pressing button
4. During the charge, the device indicates the charge progress. When indicator
Once indicator
stays on, the battery is fully charged.
5. The charge can be interrupted at any time by unplugging the mains plug or pressing button
6. After charging, disconnect the charger from the mains, then disconnect the charger's connections from the battery.
CHARGE MODES
• Modes and Options description :
CHARGE Mode (7.3V / 6A) :
Mode designed to charge and maintain (floating charge) 6V lead-acid batteries. 8 step automatic maintenance cycle.
CHARGE Mode (14.6V / 6A) :
Mode designed to charge and maintain (floating charge) 12V lead-acid batteries. 8 step automatic maintenance cycle.
«Small battery» opttion (0.8A) :
This limits the charging current to 0.8A to safely charge small batteries. Activate this option to charge
small batteries (< 15 Ah).
REFRESH Option :
Option which add an extra step (step 7) to the charge cycle to restore deeply discharged batteries.
Recommendation : Check the battery's water level and if necessary, perform with a Refresh charge.
GYSFLASH HERITAGE 6 A
. After roughly 5 seconds, the charge starts automatically.
: this option is not recommended for charging sealed batteries.
blinks, the battery is ready to start the vehicle.
.
EN
7

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Flash 6 heritageFlash heritage 6 a1616212

Tabla de contenido