Fein WSB 20-180 Manual Del Usuario página 18

3 41 01 020 06 3.book Seite 18 Dienstag, 10. Mai 2005 11:34 11
EN
Do not position your body in the area where the
power tool will move if kickback occurs.
Take special care when machining corners, sharp
edges, etc. Prevent the accessory from bouncing
off or tilting.
Do not attach a saw chain, wood-carving blade or
circular saw blade.
Additional safety instructions, particularly
for cutting operations.
Avoid jamming the cutting wheel or applying
excessive pressure. Do not attempt to make an
excessive depth of cut.
Do not position yourself in line with and behind the
rotating cutting wheel.
Switch the power tool off if the cutting wheel
blocks or if the cutting process is interrupted for
some reason. Hold the power tool motionless until
the cutting wheel has come to a complete stop.
Never attempt to remove the cutting wheel from
the cut while the wheel is still moving, otherwise
kickback may occur.
Do not restart the cutting operation if the cutting
wheel is in the workpiece. Let the cutting wheel
reach full speed and then carefully reenter the
cut.
Support the panels or any oversized workpiece to
minimize the risk of wheel pinching or kickback.
Use extra caution during "plunge cuts" in walls or
other blind areas.
Safety instructions, particularly for sanding
work with a sanding disc.
When sanding, do not use an excessively over-
sized sanding disc. Follow the manufacturer's rec-
ommendations when selecting sanding discs.
Special safety instructions for sanding work
with wire brushes.
Be aware that wire bristles are thrown by the
brush even during normal operation. Do not over-
stress the wire bristles by applying excessive load
to the brush.
If the use of a guard is stipulated for sanding with
wire brushes, do not allow the wire bristles to con-
tact the guard.