Installing Adapter Brackets - PEERLESS SmartMount ST635, SmartMount ST635-S, SmartMount ST635P, SmartMount ST635P-S Manual De Instrucciones

Installing Adapter Brackets

• If screws don't get three complete turns in the screen inserts or if screws bottom out and adapter brackets are still not
tightly secured, damage may occur to screen or product may fail. Contact customer care for correct hardware to use.
To prevent scratching the screen, set a cloth on a flat, level surface that will support the weight of the screen. Place screen
2
face side down. Place and align adapter brackets (BB & CC) on back of screen to VESA hole pattern as shown in fig. 2.1.
For additional screen compatibility please refer to the LCD interface list on our website: www.peerlessmounts.com.
Note: If mounting holes are not centered on back of screen, center brackets on back of screen as shown in fig. 2.2.
Find the VESA ® hole pattern below, and attach brackets to screen accordingly. Verify that all holes are properly
aligned, and then tighten screws using security driver (FF).
FOR VESA 75 MOUNTING PATTERN:
Attach adapter brackets (BB & CC) to back of screen using four M4 x 10 mm
screws and four #8 SAE upper washers as shown in figure 2.3.
*Note: If hole pattern is in a pocket, attach adapter brackets (BB & CC) to back of
screen using four M4 x 25 mm screws, eight #8 SAE upper and lower washers,
and four retaining spacers as indicated below.
FOR VESA 100 MOUNTING PATTERN:
Attach adapter brackets (BB & CC) to back of screen using four M4 x 10 mm
screws and four #8 SAE upper washers as shown in figure 2.3.
*Note: If hole pattern is in a pocket, attach adapter brackets (BB & CC) to back of
screen using four M4 x 25 mm screws, eight #8 SAE upper and lower washers,
and four retaining spacers as indicated below.
FOR VESA 200 MOUNTING PATTERN:
Attach adapter brackets (BB & CC) to back of screen using four M4 x 10 mm
screws and four #8 SAE upper washers as shown in figure 2.3.
*Note: If M4 x 10 mm screws gets less than three threads of engagement, attach
adapter brackets (BB & CC) to back of screen using four M4 x 25 mm screws,
eight upper and lower #8 SAE washers, and four retaining spacers as indicated
below.
FOR VESA 200 x 200 MOUNTING PATTERN:
Attach adapter brackets (BB & CC) to back of screen using four M6 x 12 mm
screws as shown in figure 2.3.
*Note: If M6 x 12 mm screw gets less than three threads of engagement, attach
adapter brackets (BB & CC) to back of screen using four M6 x 20 mm screws as
indicated below.
If M6 x 20 mm screws get less than three threads of engagement, attach adapter
brackets (BB & CC) to back of screen using four M6 x 30 mm screws as indicated
below.
fig 2.2
BB
NOTE: "X" DIMENSIONS SHOULD BE EQUAL.
Visit Peerless website at www.peerlessmounts.com
WARNING
X
CC
X
6 of 21
200 100 75
BB
ISSUED: 02-18-08 SHEET #: 202-9249-4 09-02-08
For customer care call 1-800-729-0307 or 708-865-8870
fig 2.1
SCREWS
UPPER WASHER (L)
CC
LOWER WASHER (L)
RETAINING SPACER
fig 2.3