Installation To Wood Stud Wall - PEERLESS SmartMount ST635, SmartMount ST635-S, SmartMount ST635P, SmartMount ST635P-S Manual De Instrucciones

Installation to Wood Stud Wall

• Installer must verify that the supporting surface will safely support the combined load of the equipment and all attached
hardware and components.
• Tighten wood screws so that wall plate is firmly attached, but do not overtighten. Overtightening can damage the
screws, greatly reducing their holding power.
• Never tighten in excess of 80 in. • lb (9 N.M.).
• Make sure that mounting screws are anchored into the center of the stud. The use of an "edge to edge" stud finder is
highly recommended.
• Hardware provided is for attachment of mount through standard thickness drywall or plaster into wood studs. Installers
are responsible to provide hardware for other types of mounting situations.
Use a stud finder to locate the edges of the studs. Use of an edge-to-edge stud finder is highly recommended. Based
1
on their edges, draw a vertical line down each stud's center. Place wall plate on wall as a template. The top
mounting slots should be 2.5" (65 mm) above the desired screen center as shown in figure 1.1. Level plate, and mark
the center of the two mounting holes. Make sure that the mounting holes are on the stud centerlines. Drill two 5/32"
(4 mm) dia. holes 2-1/2" (65 mm) deep. Make sure that the wall plate is level, secure it using two #14 x 2.5" wood
screws (DD) as shown in figure 1.2.
Skip to step 2.
STUD
CS = center of screen
Visit Peerless website at www.peerlessmounts.com
AA
CS
fig. 1.1
WARNING
• If wall mount is not level, it will be crooked when mounted.
AA
DD
4 of 21
For customer care call 1-800-729-0307 or 708-865-8870
CAUTION
ISSUED: 02-18-08 SHEET #: 202-9249-4 09-02-08
fig. 1.2