Technical Data - YATO YT-0927 Manual De Instrucciones

PROPERTIES OF THE TOOL
The gas nailing tool is powered by the energy in the gas cartridge, and its purpose is to connect elements with nails. Thanks to the
gas cartridge and the battery it is a wholly cordless device, which hugely facilitates connecting elements. A correct, reliable and
safe functioning of the tool depends upon its proper operation, therefore:
Before you commence to work with the tool, read the whole manual and keep it.
The supplier will not be held responsible for any damage and injuries caused by operation of the tool for any purpose other than
intended or by inobservance of safety regulations and recommendations indicated in the present manual. Should the tool be used
for any purpose other than intended, the guarantee will become void and the user will loose any contractual rights.
EQUIPMENT
The nailing machine is equipped with two replaceable batteries and a charging station with a power pack. Gas cartridges and
nails are not included.

TECHNICAL DATA

Parameter
Catalogue number
Weight
Dispenser capacity
Kind of joining elements
Length of joining elements
Dimensions of joining elements
Maximum capacity
- intermittent work
- continuous work
Kind of gas cartridge
Kind of gas
Maximum capacity of the gas cartridge
Maximum capacity of the battery
Maximum working pressure p
s max
Acoustic pressure (EN 12549:1999, EN ISO 4871)
Acoustic power (EN 12549:1999, EN ISO 4871)
Vibrations (PN-EN ISO 8662-7:2000)
Battery
Type
Nominal voltage
Nominal capacity
Power pack
Nominal input voltage
Nominal input voltage frequency
Nominal output voltage
Nominal input current
Charging time
GENERAL SAFETY CONDITIONS
WARNING! While working with the gas cartridge tool, it is recommended to always observe the general safety regulations,
including the ones specifi ed below, in order to limit the risk of fi re, electric shock and to avoid injuries.
Before you commence to work with the tool, read the whole manual and keep it.
NOTE! Read all the instructions below. Their violation may lead to electric shock, fi re or injuries. The term „gas cartridge tool" used
in the manual refers to all the tools powered by the energy accumulated in a gas cartridge.
OBSERVE THE FOLLOWING INSTRUCTIONS
O P E R A T I
GB
Unit
[kg]
[pieces]
[mm]
[nails/s]
[nails/h]
[nails]
[nails]
[bar]
[dB(A)]
[dB(A)]
[m/s ]
2
[V]
[mAh]
[V]
[Hz]
[V]
[mA]
[h]
N G M A
Value
YT-0927
3,27
50
nails
50 - 90
drawing II
1 - 2
1000
40 g/ 80 ml
liquid hydrocarbon
1200
4000
42
96,6 ± 3,0
109,6 ± 3,0
5,07 ± 1,5
Ni-MH
6 dc
2000
~230
50
6 dc
600
2 - 3
N U A L
13