Sharp PG-LX2000 Guia De Inicio Rapido página 13

Tabla de contenido

Publicidad

4. Adjust the projected image with the Setup Guide
1
After the projector turns on, the Setup Guide appears.
(When "Setup Guide" is set to "On". See the projector's operation manual.)
2
Follow the steps in the Setup Guide and adjust the focus, height (angle) and picture size.
3
After adjusting the focus, height (angle) and picture size, press ENTER to fi nish the
Setup Guide.
5. Correct trapezoidal distortion
Correcting trapezoidal distortion using Keystone Correction.
On the remote control
6. Select the Input mode
Press INPUT P/R to display the INPUT list. Use INPUT P/R to select the Input mode.
On the
On the remote
projector
control
[PG-LX2000 only]
When you select HDMI input, use O/Q to select the audio input terminal (HDMI or AUDIO).
7. Turn the computer on
8. Turn the power off
Press STANDBY/ON on the projector or STANDBY on the remote control, and then press
the button again while the confi rmation message is displayed to put the projector into
Standby mode.
On the
projector
Shrinks
upper side.
INPUT list (e.g. PG-LX2000)
INPUT
COMPUTER
HDMI
H
VIDEO
V
On the remote
control
Audio
On-screen display
Shrinks
lower side.
13

Publicidad

Tabla de contenido
loading

Este manual también es adecuado para:

Pg-ls2000

Tabla de contenido