Storing A Redial Number; Inserting A Pause In The Dialing Sequence; Reviewing , Changing Or Deleting; Stored Numbers - GE 21015 Manual De Instrucciones

S R
TORING A EDIAL
1. Make sure the phone is OFF (not in talk mode).
2. Press the mem button.
3. Press any number key (01-50) to store the phone number in that
memory location, or press the
select the memory location.
4. Press the mem button and ENTER NAME shows in the display.
5. Use the touch-tone pad on your handset or base to enter the name, then
press the mem button and ENTER TEL NUMBR shows in the display.
6. Press the redial button to display the redial number.
7. Press the mem button again to confirm.
NOTE: If the redial number has more than 20 digits, the redial number
cannot be stored in base or handset memory.
I P
NSERTING A
If a pause is needed to wait for a dial tone press the # pause button to
insert a delay in dialing sequence of a stored telephone number (for
example, after you dial 9 for an outside line, or to wait for a computer
access tone.) Each pause counts as one digit in the dialing sequence.
R , C
EVIEWING HANGING OR
T R :
O EVIEW
1. Make sure the phone is OFF (not in talk mode).
2. Press the mem button.
3. Press the or
stored numbers. Or use the touch-tone pad on your handset or base to
enter the memory location number.
32
N
UMBER
D
AUSE IN THE
D
button on the handset or base to scroll through the
or button on the handset or base to
S
IALING EQUENCE
S
ELETING TORED
0 3
MEMO
317 - 123 - 4567
PETER CHAN
N
UMBERS