Cleaning And Maintenance - ARIETE 6408/8 Manual De Instrucciones

cleAnInG AnD MAInTenAnce

Warning!
Before cleaning, always disconnect the plug from the power point and allow the iron to cool down on its stand grille.
Warning!
Never immerse the appliance in water or other liquids.
Warning!
Check the state of the power cable of your iron on a regular basis before using it, and if it is damaged, take it to the
service centre closest to you to have it replaced only by specialised personnel.
cleaning the soleplate
Any deposits and other residue material on the soleplate can be removed using a cloth soaked in a water and vinegar solu-
tion. Always dry the soleplate with a dry cloth.
Warning!
Do not use abrasives for cleaning the soleplate. Try and keep the soleplate smooth: avoid contact with metal objects.
cleaning the tank
Clean the water tank from time to time by putting fresh water in it. rinse and empty (Fig. 10).
Warning!
Do not put vinegar, decalcifying products or other additives in the tank; Otherwise, the warranty may be revoked.
cleaning the iron
Clean plastic parts with a damp, non-abrasive cloth and dry them with a dry cloth.
emptying the boiler and cleaning it internally
Warning!
If an ironing operation has only recently finished, switch off the appliance, disconnect the power cable from the
mains. Wait at least two hours, until the appliance is cold and the internal pressure is depleted, before unscrewing
the cap (P).
Warning!
Do not put vinegar, decalcifying products or other additives in the boiler; Otherwise, the warranty may be revoked.
remove the tank (o) and empty it completely before you empty the boiler (Fig. 10).
Position the appliance so that the boiler safety cap is uppermost. unscrew the boiler safety cap (P) using a normal screw-
driver (Fig. 11). Turn the appliance upside-down over a sink and completely empty the boiler.
Place one measuring cup of tap water in the boiler (Fig. 13). Shake the appliance well, then empty it again of all the water.
repeat this operation until the water coming out of the boiler is clean and clear.
After cleaning the boiler, pour approx. 400 cc of water into the boiler (Fig. 13) and refit the cap (P) tightening it slightly,
without forcing it excessively. refit the cover.
Clean the boiler at least every two months so as to eliminate any residue of lime that could jeopardize proper
operation of the appliance.
the Warranty does not Cover damage Caused By CLogging due to Lime.
note: it is absolutely normal that the white plastic parts of the iron slightly change in colour after a certain period
of use at high temperatures.
17