Zone 2 Output Of An A/V Or Stereo Receiver - ATON DLA2RF Manual De Instrucciones

Zone 2 Output of an A/V or Stereo Receiver

Certain A/V Receivers and Stereo Receivers have a Zone 2 feature that allows them to play a
seperate source to a second zone. Figure 2-2 shows the Zone 2 speaker outputs of an A/V
receiver connected to to the AMPLIFIER INPUT of the DLA2RF. Like the previous example, a pair
of speakers are connected to the DLA2RF's Room 1 Speaker Outputs, while an additional pair
of speakers is connected to the Room 2 Speaker Outputs. The RF RECEIVER BASE is connected
to the ATON PORT. This application allows the A/V receiver's Main speakers to play in the room
in which the receiver is located, while two additional pairs of speakers play in other areas of
the home-each controlled by the RF remote included with the DLA2RF. This is a multi-source
application: the Main speakers may play one source, while Zone 2 (the DLA2RF loactions) plays
a different source.
Note: Set the Zone 2 volume level to the point where it achieves the maximum listenable
level (prior to distortion). The DLA2RF's volume level will adjust up to this maximum level.
PS3
POWER
SUPPLY
AMPLIFIER
PATENT
INPUT
PENDING
PWR IN
12VDC / 2.1A
CLASS 2 WIRING
Speaker
Cables
L R
+
-
ZONE 1 ZONE 2
A/V Reciever
Zone 2
Speaker Outputs
8
RF
Base
IR EMITTER
OUTPUTS
ATON
PORT
L R
Figure 2-2: A/V Receiver Zone 2 Application
DLA2RF 2 Room Speaker Selector
1
Speaker
Cables
Room 1
Speakers
©2007 • All rights reserved.
Room 2
Speakers