Connections; Amplifier Input - ATON DLA2RF Manual De Instrucciones

DLA2RF 2 Room Speaker Selector

3. Connections

AMPLIFIER INPUT

Use 16 AWG stranded copper speaker wire to connect from a speaker level output of an A/V
receiver, stereo receiver, or amplifer. Turn power for the output device OFF before making con-
nections.
To make connections:
1. Cut the ends of the wire to length, allowing some free play (about 6 inches
of slack) to allow for movement when physically connecting the wire.
2. Using wire strippers, remove 3/8 inch of insulation, then twist the wire to
ensure that no stray strands are evident.
3. Defi ne positive (+) and negative (-) at the amplifi er end and the DLA2RF
end of the wire run and use the same conductor on each end.
4. Lift up each fl ip-lock connector until it is locked in the up position.
5. Place the bare lead from each speaker wire from the receiver/amplifi er
into the holes of the Amplifi er Inputs terminal of the DLA2RF, maintaining
the polarity of each lead (+ to +, - to -).
Note: To avoid damage to the receiver/amplifi er, DO NOT allow speaker leads to touch
each other.
125 Watts
per Channel
Max
Figure 3-1: Receiver/Amplifi er Output to DLA2RF Amplifi er Input
© 2007 • All rights reserved.
DLA2RF
AMPLIFIER
INPUT
CLASS 2 WIRING
Speaker
Cables
L R
+
-
A
Receiver/Amplifier
Output
L R
B
11