Rf Remote Control - ATON DLA2RF Manual De Instrucciones

DLA2RF 2 Room Speaker Selector

RF Remote Control

The RF Remote Control uses Radio Frequencies (RF) to control the rooms in the system from
anywhere in the home. It is not necessary to point the remote at the main unit in order for it
to function. Simply connect the RF Receiver base to the ATON Port on the rear of the unit as
described in Chapter 3. See Figure 3-3 for details.
Button
Room 1
Room 2
ALL ON
ALL OFF
SCENE
MUTE (Toggle)
VOL +
VOL -
© 2007 • All rights reserved.
ROOM 1 ROOM 2
ALL
SCENE
ON
ALL
MUTE
OFF
Figure 4-2: ATON RF Remote
Function
Selects Room 1 for Adjustment
Selects Room 2 for Adjustment
Turns all Rooms ON
Turns all Rooms OFF
Places Rooms into Scene Preset Mode
Press to Reduce Volume of Selected Room to 0
Press Again to Restore Volume to Previous Level
Increases Volume of Selected Room by One Step
Press & Hold to Ramp Volume Up
Decreases Volume of Selected Room by One Step
Press & Hold to Ramp Volume Down
Table 4-1: RF Remote Functions
VOL
+
-
VOL
19