Scene Presets; Setting A Scene - ATON DLA2RF Manual De Instrucciones

DLA2RF 2 Room Speaker Selector
ROOM 1
5. After 3 seconds the Default Volume Level is saved.
6. Room LED and Volume LED's blink four times (Room LED blinks RED).
7. The Room will turn back on to the volume level it was set to prior to setting the
Default Volume Level.
8. Turn the Room Off, then back On to achieve the Default Volume Level.
Note: Setting the Default Volume level to the maximum volume level will essentially dis-
able Default Volume (the room will always come back on at the last volume level prior to
turning the room Off).

Scene Presets

Setting a Scene

A Scene Preset allows the volume level for each room to be saved and then recalled at any time
with the press of a button.
To set a Scene Preset:
1. Set the volume in each room to the desired level.
Note: Any room whose LED is not lit (red or blue) or any room whose volume is set to
"0" will be considered OFF when setting a Scene.
2. Press and hold the ALL ON/OFF Button for three seconds.
ROOM 1
3. Once the Scene Preset has been saved, the Room LEDs for the rooms included in
the Scene Preset will blink on and off four times and the system will return to the
levels prior to setting the Scene Preset.
Note: If a Room LED does NOT blink, it will not be activated when a Scene is selected.
© 2007 • All rights reserved.
Press
& Hold
Press
& Hold
Press
& Hold
ROOM 2
ROOM 2
17