Campbell Hausfeld CE1000 Instrucciones De Operación página 19

Belts
Lock out and tag the power then release all pressure from the tank to prevent unexpected movement of the unit.
Check belt tension every 3 months. Adjust belt tension to allow 3/8 inch to 1/2 inch deflection with normal
thumb pressure. Also, align belts using a straight edge against the face of the flywheel and touching the
rim on both sides of the face. The belts should be parallel to this straight edge (see Figure 15). Dimension A
should be the same as B and C to ensure proper alignment of the belts.
Slots in the bed-plate allow for sliding the motor back and forth to adjust belt tension.
Air Compressor
Flywheel
Straight Edge
Figure 15 - Top View
Removing Belt Guard
When removing belt guard front to inspect or replace belts, inspect
plastic retaining clips and replace if damaged or if clip can be
removed without a tool.
Removing Retaining Clips
1. Using crescent wrench on pliers, rotate clip 90°.
2. Pull clip out and away from beltguard.
3. Reverse process to reinstall after inspecting the clip.
Storage
If compressor is to be stored for a short period of time, make sure that it is stored in a normal position and
in a cool protected area.
OPERATION
Check Oil Level
Drain Tank
Check Air Filter
Check Safety Valve
Clean Unit
Check Belt Tightness
Change Oil*
* Change oil after first fifty (50) hours of operation then perform oil changes every three (3) months or two hundred
(200) hours of run time, whichever comes first.
Motor
A B
Setscrew
MAINTENANCE SCHEDULE
DAILY WEEKLY
l
l
l
l
17
Motor
Drive
Pulley
C
1
2
Figure 16
MONTHLY 3 MONTHS
l
l
l