Bosch 1619EVS Instrucciones De Funcionamiento Y Seguridad página 17

BM2610995777 9/00 9/13/00 4:20 PM
Preparation For Use With RA1200 Router Table
Your router is uniquely suited for use in the
Bosch RA1200 router table. For detailed
instructions about router table procedures,
please refer to the manual that is supplied with
the router table. To prepare the 1619EVS for
table mounting, do the following:
HOUSING
1. Engage plunge lock override lever as follows:
Facing the rear of the router, move plunge
lock lever approximately 90 degrees
clockwise. Depress small override lever and
slowly release plunge lock lever until override
lever catches firmly on metal housing as
shown in diagram. The motor is now free to
move up and down on the posts (Fig. 22).
2. Engage the plunge return spring defeat
(Fig. 23).
Note: This unique feature makes it easier to
adjust the height of the bit when the router is
mounted under a router table.
a. Move the depth rod to its highest position,
and lock in place with coarse adjustment lock.
b. Remove the collet chuck.
c. Rotate depth stop turret to the position shown
in Fig. 23.
Page 17
d. Plunge the router motor down as far as it
will go.
e. While holding the motor down, press and hold
down spring defeat button.
f. Allow the motor to move up slightly.
g. Release the button.
FIG. 22
The plunge return spring pressure is now
disengaged.
PLUNGE LOCK
OVERRIDE LEVER
PLUNGE
LOCK LEVER
3. Connect the depth rod to the depth stop
turret by rotating the depth stop turret so that
the large end of keyhole slot is aligned with
the lower end of the depth rod. Release
coarse adjust lock, and lower depth rod into
COARSE
the large end of keyhole slot. Rotate depth
ADJUSTMENT
stop turret until the smaller end of the keyhole
LOCK
traps the end of depth rod (Fig. 24). (To keep
the rod in the keyhole, there is a raised rim
FIG. 23
around the underside of the smaller end of the
keyhole. When inverted, the weight of the
router keeps the depth rod inside the raised
SPRING
rim.) Note: When the router motor is at its
DEFEAT BUTTON
further point away from the base, the motor
must be moved slightly closer to the base so
the depth rod can clear the raised rim.
-17-
FIG. 24
DEPTH ROD
SPRING DEFEAT
BUTTON
KEYHOLE
DEPTH STOP
TURRET