Via The Euroconnector; Av-1 S Mode; Via The Rca Jacks; Via The Ant (Aerial) Socket - JVC AV21BJ8EPS Manual De Instrucciones

Via the Euroconnector

Your TV set has an Euroconnector socket. If you want to
connect equipments (e.g. video recorder, decoder, etc.) which
have Euroconnectors, to your TV, use the
AV-1 S (SCART 1) terminals.

AV-1 S Mode

If the equipment connected to your TV set supports S-Video
(Y/C) output from Euroconnector, you can have a better pic-
ture quality by selecting
equipment to the AV-1 S (SCART 1)
equipment's booklet to check if your equipment has such fea-
ture.

Via the RCA jacks

If you have an equipment (such as a Camcorder) which has
the RCA jacks, connect it to the
with the video and audio cables.

Via the ANT (aerial) socket

If your equipment does not have an Euroconnecter or RCA
jacks, connect it to the TV with an aerial cable. For details,
see the manual provided with the equipment.
• To store the test signal that comes from the equipment, see
"INSTALL. Menu" on page 7 and store it to the programme
number 0. You can watch images from that equipment to
select the programme number which you stored the test
signal.

TV and Video Recoder (VCR)

• Connect the Video Recorder to the ANT (antenna input)
socket of the TV with the aerial cable.
• Connect the Video Recorder to the
with the SCART cable, or connect it to the
terminal with the audio and video cables.

NTSC Playback

Connect a NTSC video recorder to a terminal. Then press
“AV“ button to select the corresponding AV mode.
NTSC 3.58/4.43 system is detected automatically in AV
mode.

Connecting Headphones

Use the headphone socket of your TV, to connect head-
phones.
AV-1 (SCART 1) or
AV-1 S mode and connecting your
terminal of TV. See your
F-AV (Front AV)
AV-1 or AV-1 S
F-AV (Front AV)

Tips

Care of the Screen:
Clean the screen with a slightly damp, soft cloth. Do not use
abrasive solvents as they may damage the TV screen coating
layer.
Poor Picture:
Have you selected the correct TV system? Is your TV set or
house aerial located too close to the loudspeakers, non-
earthed audio equipment or neon lights, etc. ?
Mountains or high buildings can cause double pictures or
ghost images. Sometimes you can improve the picture quali-
ty by changing the direction of the aerial.
The picture quality may degrade when two peripherals are
connected to the TV at the same time. In such a case, dis-
connect one of the peripherals.
terminal
No Picture:
Is the aerial connected properly? Are the plugs connected
tightly to the aerial socket? Is the aerial cable damaged? Are
suitable plugs used to connect the aerial? If you are in doubt,
consult your dealer.
No Picture means that your TV is not receiving any trans-
mission. Have you pressed the correct keys on the remote
control? Try once more.

Remote Control:

Your TV no longer responds to the remote control. Press the
“STANDARD” button on the remote control once more. Per-
haps the batteries are exhausted. If so you can still use the
local buttons at the front of your TV.
Have you selected the wrong menu? Press “STANDARD” but-
terminal
ton to return to TV mode or press “MENU” button to return to
the previous menu.
No solution:
Switch your TV set off and on. If this does not work, call the
service personnel; never attempt to repair it yourself.
ENGLISH - 11 -