Inserting/Changing The Battery - Flex ALi 10.8 B Instrucciones De Funcionamiento Originales

ALi 10.8 B/ALi 10.8 G/ALi 10.8 S

Inserting/changing the battery

 Press charged battery fully into the power
tool.
 To remove the battery, press the release
buttons and pull out the battery.
Inserting the tools
`^rqflk>
_ÉÑçêÉ=éÉêÑçêãáåÖ=~åó=ïçêâ=çå=íÜÉ=éçïÉê=íççäI=
ëÉí=íÜÉ=ÇáêÉÅíáçå=çÑ=êçí~íáçå=ëÉäÉÅíçê=ERF=íç=íÜÉ=
ãáÇÇäÉ=éçëáíáçåK
Keyless chuck (ALi 10.8 G)
klqb
The chuck securely holds drill bits with
a diameter of 0.8–10 mm, ¼" screwdriver bits
as well as ¼" bit holders.
 Hold the power tool with one hand and
rotate the chuck with the other hand.
– To open the chuck, rotate it counter-
clockwise.
– To close the chuck, rotate it clockwise.
 Insert tools.
 Close the chuck fully.
 Carry out a test run to check that the tool is
clamped in the centre.
Tool holder (ALi 10.8 B/ALi 10.8 S)
klqb
¼" screwdriver bits and ¼" bit holders are held
securely in the chuck.
 Insert tool into the tool holder.
ALi 10.8 B:
ALi 10.8 S:
 Pull tool lock forwards and press in the tool
all the way.
 Release tool lock.
 To remove the tool, pull tool lock
backwards.
17