Speed Preselection; Direction Of Rotation - Flex ALi 10.8 B Instrucciones De Funcionamiento Originales

Torque preselection
(ALi 10.8 B/ALi 10.8 G)
`^rqflk>=
Do not change torque until the power tool
is at a standstill.
ALi 10.8 B:
ALi 10.8 G:
 Set torque preselection to the required
setting:
– 1 – 10 : Screw position (ALi 10.8 B)
or
– 1 – 20 : Screw position (ALi 10.8 G)
– : Drill position
klqb
– The friction clutch is deactivated in the drill
position .
– At the correct setting the tool stops as soon
as the screw has been screwed in flush.
18
ALi 10.8 B/ALi 10.8 G/ALi 10.8 S

Speed preselection

ALi 10.8 G:
 Set selector switch to the required setting (H
= quick/L = slow).

Direction of rotation

`^rqflk>=
aç=åçí=ÅÜ~åÖÉ=ÇáêÉÅíáçå=çÑ=êçí~íáçå=ìåíáä=
íÜÉ éçïÉê=íççä=áë=~í=~=ëí~åÇëíáääK
 Set switch for selecting direction of rotation
to the required position:
– Left: counter-clockwise
(unscrew screws)
– Right: clockwise
(drilling, inserting screws)
– Middle: Starting lockout (tool change,
for all work on the power tool)