Noise And Vibration - Flex ALi 10.8 B Instrucciones De Funcionamiento Originales

ALi 10.8 B/ALi 10.8 G/ALi 10.8 S
 Protect the battery charger from humidity,
rain, snow and frost.
 Do not open the battery. Risk of short-
circuit!
 Protect the battery from heat (e.g. strong
sunlight) and fire. Risk of explosion!
 Never short-circuit the battery.
Risk of explosion!
 If the battery is damaged or used
improperly, fumes may escape.
Risk of damage to health! Supply fresh air.
If you feel unwell, call a doctor.
`^rqflk>
 The mains voltage must correspond with
the voltage information on the rating plate
of the battery charger.
 Do not actuate the direction of rotation
selector (5) or torque setting (4) until the tool
is at a standstill.

Noise and Vibration

The noise and vibration values have been
determined in accordance with EN 60745.
ALi 10.8 B/ALi 10.8 S
The A-weighted sound pressure level of the
power tool is typically: sound pressure level
72 dB(A); sound power level 83 dB(A);
uncertainty K = 3 dB. Wear ear protection!
Total vibration values (vector sum in three
directions) determined in accordance with
EN 60745:
Screwing:
Vibration emission value a
uncertainty K = 1.5 m/s
ALi 10.8 G
The A-weighted sound pressure level of the
power tool is typically: sound pressure level
72 dB(A); sound power level 83 dB(A);
uncertainty K = 3 dB. Wear ear protection!
Total vibration values (vector sum in three
directions) determined in accordance with
EN 60745:
2
=1.25 m/s ,
h
2
.
Drilling in metal:
Vibration emission value a
uncertainty K = 1.5 m/s
Screwing:
Vibration emission value a
uncertainty K = 1.5 m/s
ALi 10.8 B/ALi 10.8 G/ALi 10.8 S
The vibration emission level given in this
information sheet has been measured
in accordance with a standardised test given
in EN 60745 and may be used to compare
one tool with another. It may be used
for a preliminary assessment of exposure.
The declared vibration emission level
represents the main applications of the tool.
However if the tool is used for different
applications, with different accessories
or poorly maintained, the vibration emission
may differ. This may significantly increase
the exposure level over the total working
period.
An estimation of the level of exposure to
vibration should also take into account the
times when the tool is switched off or when it is
running but not actually doing the job.
This may significantly reduce the exposure
level over the total working period.
Identify additional safety measures to protect
the operator from the effects of vibration such
as: maintain the tool and the accessories,
keep the hands warm, organisation of work
patterns.
2
< 2.8 m/s ,
h
2
,
2
= 1.25 m/s ,
h
2
.
15