Operating Instructions - Flex ALi 10.8 B Instrucciones De Funcionamiento Originales

Operating instructions

Before switching on the power tool
Unpack power tool and accessories
and check that no parts are missing
or damaged.
Charge batteries
klqb
The supplied batteries are not fully charged.
Before using the power tool for the first time,
charge the batteries fully.
Information to ensure a long battery
service life
`^rqflk>
Ó kÉîÉê=ÅÜ~êÖÉ=Ä~ííÉêáÉë=~í=íÉãéÉê~íìêÉë=
ÄÉäçï=R ø`=çê=~ÄçîÉ=QM ø`K
Ó aç=åçí=ÅÜ~êÖÉ=Ä~ííÉêáÉë=áå=~å=ÉåîáêçåJãÉåí=
ïáíÜ=ÜáÖÜ=~áê=ÜìãáÇáíó=çê=~í=~=ÜáÖÜ=~ãÄáÉåí=
íÉãéÉê~íìêÉK
Ó aç=åçí=ÅçîÉê=Ä~ííÉêáÉë=~åÇLçê=íÜÉ=Ä~ííÉêó=
ÅÜ~êÖÉê=ÇìêáåÖ=íÜÉ=ÅÜ~êÖáåÖ=éêçÅÉëëK
Ó ^í=íÜÉ=ÉåÇ=çÑ=íÜÉ=ÅÜ~êÖáåÖ=éêçÅÉëë=éìää=çìí=
íÜÉ=Ä~ííÉêó=ÅÜ~êÖÉê=ã~áåë=éäìÖK
The battery and battery charger heat up during
the charging process. This is normal!
Lithium ion batteries do not exhibit the well
known "memory effect". Nevertheless, before
a battery is recharged, it should be fully
discharged and the charging process always
run to the end.
If the batteries are not used for a prolonged
period, store batteries partially charged and in
a cool location.
16
ALi 10.8 B/ALi 10.8 G/ALi 10.8 S
Charging process
`^rqflk>
rëÉ=çåäó=çêáÖáå~ä=Ä~ííÉêáÉë=áå=íÜÉ=ëìééäáÉÇ=
Ä~ííÉêó=ÅÜ~êÖÉêK
 Insert the mains plug of the battery charger.
The green operating status LED lights up.
 Insert battery fully into the battery charger.
The red charging status LED lights up.
The red LED goes out after approx. 1 hour
when the battery is fully charged.
 Take the battery out of the battery charger.
 Pull out the mains plug.
klqb
If both LEDs flash alternately when the battery
has been inserted, the battery may be too cold
or too hot. When the battery has reached a
temperature of 5 °C–40 °C, the red LED
should be lit constantly and the charging
process should start. If the LEDs are still
flashing after one hour, the battery is defective.
Pull out the mains plug.