Bowers & Wilkins CM Serie Manual De Instrucciones página 4

1. Unpacking
Carton Contents
Check in the carton for:
1 Two-part foam plug
1 Plinth
1 Accessory pack containing
4 M4 spike feet
4 Rubber feet
4 Lock nuts (10mm across flats)
1 Accessory pack containing
1 Allen key
4 M6 x 35mm screws
4 Plain washers
4 Shakeproof washers
Environmental Information
This product complies with international directives,
including but not limited to the Restriction of Hazardous
Substances (RoHS) in electrical and electronic equipment,
the Registration, Evaluation, Authorisation and restriction of
CHemicals (REACH) and the disposal of Waste Electrical
and Electronic Equipment (WEEE). Consult your local waste
disposal authority for guidance on how properly to recycle or
dispose of this product.
4
2. Positioning
CM9

CM8

Speaker Installation
The speakers are intended to be floor mounted only. It is
important to ensure that the speakers stand firmly on the
floor using the spike feet supplied whenever possible. In
addition, fit the plinth for proper stability.
To attach the plinth, stand the speaker on its top taking care
not to damage the cabinet or the drive units during handling.
Align the plinth with its attachment holes in the underside of
the cabinet, ensuring that the arrow on the underside of the
plinth points forwards. Secure the plinth using the screws and
washers supplied. Fit the shakeproof washers between the
plain washers and the screw heads. Tighten the screws using
the Allen key supplied.
The spike feet are designed to pierce carpet and rest on the
floor surface. Initially, screw the lock nuts onto the spikes
enough to leave the nuts floating just above the carpet when
the spikes are resting on the floor beneath. Screw the spikes
fully into the threaded inserts in the plinth. If the cabinet
rocks when placed on the floor, unscrew the two spikes that
do not touch the floor until the cabinet rests firmly without
rocking. Finally, lock the nuts against the cabinet. It may be
more convenient to fit and adjust the spike feet after speaker
positioning has been optimised.
If there is no carpet and you wish to avoid scratching the floor
surface, use either a protective metal disc (a coin perhaps)
between the spike and the floor, or use the supplied rubber
feet. Fit the rubber feet and level the cabinet in the same
manner as with the spike feet.