Preparing The Appliance; Rinsing Of Circuits; Preparing The Grinder - Krups EA 8108 Manual De Instrucciones

Pull out and fill the
water tank.
Do not fill the water tank with hot water, milk or any other liquid. If you turn on the appliance when the water tank is
not in place or not correctly filled (under the "min. " level,), the "fill water tank" light will come on and making an espresso
or a cup of coffee will be made impossible.
NEVER PUT GROUND COFFEE IN THE COFFEE CONTAINER.
It is recommended that you do not use oily, caramelised or flavoured coffee beans for this machine. These kinds of beans
may damage the machine.
Check that the coffee beans do not contain any foreign particles such as grit, as any damage caused by the presence of
foreign particles will negate the warranty.
Do not put water into the coffee bean container.
Remember to fit the drip tray to avoid waste water flowing onto the work surface and staining it or scalding you.
Check that your water tank is clean.
Turn the appliance on by pressing the
button. The light will flash during the
pre-heating and initialisation cycle.
It is preferable to rinse the 2 circuits out at least once after the machine has not been used for several days.
Each time you plug your machine in, it will carry out an initialisation cycle.
You can choose the strength of your coffee by setting the coffee bean grinding fineness.
The finer the grinding setting, the stronger and creamier the coffee should be. Set the desired fineness for grinding by tur-
ning the 'Grinding fineness setting' knob.
CHANGE THE SETTING DURING GRINDING.
NEVER FORCE THE GRINDING FINENESS SETTING BUTTON

PREPARING THE APPLIANCE

Put it back in place by
pressing firmly and
close the lid again.

RINSING OF CIRCUITS

Rinsing out the coffee circuit:
Place a recipient under the coffee nozzles.
Press the 'Service' button quickly to start a
coffee circuit rinsing cycle, which will automa-
tically stop after around 40 mL.

PREPARING THE GRINDER

Turn to the left
for finer grind.
Open the coffee bean
container lid. Add the
coffee beans (250 g
maximum).
Turn to the right
for coarser
grind.
5
Close the coffee bean
container lid again.
Rinsing out the steam circuit:
Place a container under the steam
nozzle and press the 'Service' button
for 3 seconds to start a steam circuit
rinsing cycle, which will automatically
stop after around 300 mL.