EMPTYING THE COFFEE GROUNDS COLLECTOR, THE COFFEE TRAY
The drip tray receives waste water and the coffee grounds collector receives used coffee grounds.
The coffee cleaning tray allows you to eliminate any deposits of coffee grounds.
If the
light comes
Remove, empty and
clean the coffee
on, remove, empty and
grounds collector.
clean the drip tray.
As soon as you remove the coffee grounds collector, you will have to empty it completely to avoid any overflow.
The
light will remain on if the coffee grounds collector is not slotted in fully or not fitted correctly or if
it has been put back in less than 4 seconds. You cannot make espresso or coffee while the
flashing. The coffee grounds collector has a capacity of 9 coffees.
MACHINE CLEANING PROGRAM – TOTAL DURATION: ABOUT 20 MINUTES
When a cleaning operation is necessary, the appliance warns you of this by flashing the "clean" light.
This program is only accessible when the machine requests it (i.e. approximately every 300 coffees or espressos).
Caution! To benefit from the guarantee conditions, it is essential to perform the appliance cleaning cycle
when informed to do so. Be sure to follow the procedure closely, step by step.
You can continue to use the appliance when the light is on, but you are advised to perform the program as soon as possible.
Press the 'Service'
button to start up the
cleaning program.
The 'clean' and
lights will flash.
Remove and empty the
drip tray.
MAINTAINING YOUR APPLIANCE
AND THE DRIP TRAY
Remove the coffee
cleaning tray.
RINSING OUT THE CIRCUITS: SEE PAGE 5
Remove and clean
the cleaning tray then
fit it again.
Remove, fill and re-fit
the water tank.
8
The drip tray is equipped
Clean it under water
and dry thoroughly.
with floats to tell you
when to empty it.
Empty and clean the
coffee grounds collector
then fit it again.
The
Place a receptacle with a
minimum capacity of 0.6 l
under the coffee outlets.
light is on or is
light will go off.