Nilox TUBE Manual Del Usuario página 6

TUBE
CHARGING
The photo camera can be charged by connecting both the USB cable and a AC/DC adapter (not included) to a
PC.
The red LED will indicate that the photo camera is charging and will be off when the battery is fully charged.
The charging operation will need 2 hours.
PLUGGING THE MEMORY CARD
TUBE allows an hermetic closing to water up to 10 meters (30 feet).
It is necessary to close tightly the camera with the back cover to protect it, when used in wet conditions.
data loss.
The warranty does not cover damages caused by water or by misuse of the video camera. The rubber seal on
the cover works as waterproof barrier to protect the photo camera in case of wet conditions or during diving
and must be constantly kept cleaned.
After the use in salty water wash the product outside and the seal with fresh water and wipe it carefully. Lack
of cleaning may cause corrosion of the product or the breaking of the seal, with further damage to the TUBE.
Plug the MicroSD card (not included in the package) before the use.
Make sure that the photo camera is off before inserting the card in the slot.
Note:
The correct MicroSD inserting side is only one.
Do not force when inserting as this may damage both the camera
and the card.
Please format the new MicroSD before the use.
TUBE
HERMETIC CLOSING
Rotate clockwise the cover on the back side of the TUBE to fix it, until the two black
points are aligned; slide the lock on the back
cover to block it.
To unlock proceed backwards.
Note:
Any failure to observe these precautions
may cause the entrance of water in the
electronic components of TUBE, with consequent damage to the device and