Before Operation - Metabo HPT NV 75A5 Instrucciones Y Manual De Seguridad

English
ACCESSORIES
WARNING
● Accessories other than those shown below can
lead to malfunction and resulting injuries.
STANDARD ACCESSORIES
1
1 Eye protection ......................................................... 1
2 Nose cap ................................................................. 1
3 Hook ........................................................................ 1
OPTIONAL ACCESSORIES
○ Pneumatic Tool Lubricant
.8 oz. (25 cc) oil feeder
4 oz. (120 cc) oil feeder
1 quart (1 ltr) can
NOTE: Accessories are subject to change without any
obligation on the part of metabo HPT.
APPLICATIONS
○ Floor and wall framing
○ Siding, fencing, decking
○ Wall and roof sheathing
○ Mobile home and modular housing construction
○ Crate and pallet construction
NOTE:
○ .131" × 3" (3.3 mm × 75 mm) nails cannot be driven
in some cases, depending on the material. Test drive
some of the nails fi rst to check before using.
○ Aluminium nails may bend when used on hard
surfaces.
Test before use.
10
3
2
... sold separately
(Code No. 877153)
(Code No. 874042)
(Code No. 876212)

BEFORE OPERATION

Read section titled "SAFETY" (pages 3 – 7).
Make sure of the followings before operation.
WORKING ENVIRONMENT
● No fl ammable gas, liquid or other fl ammable
objects at worksite.
● Clear the area of children or unauthorized
personnel.
AIR SUPPLY
● NEVER use reactive gases or
● Never connect
which potentially
(13.7 bar 14 kgf/cm
● Never use non relieving coupler on Nailer.
1. Power source
○ Use only clean, dry, regulated compressed air as a
power source for this Nailer.
○ Air compressors used to supply compressed air to
this Nailer must comply with the requirements of
the latest version of ANSI Standard B 19.3 "Safety
Standard For Compressors For Process Industries."
○ Moisture or oil in the air compressor may accelerate
wear and corrosion in the Nailer.
Drain daily.
2. Filter-Regulator-Lubricator
○ Use a regulator with a pressure range of 0 – 120 psi
(0 – 8.3 bar 0 – 8.5 kgf/cm
○ Filter-regulator-lubricator units supply an optimum
condition for the Nailer and extend the Nailer life.
These units should always be used.
Filter ............ The fi lter removes moisture and dirt
mixed in compressed air.
Drain daily unless fi tted with an
automatic drain.
Keep the fi lter clean by regular
maintenance.
WARNING
DANGER
other bottled
Explosion may occur.
WARNING
Nailer to pressure
exceeds 200
) if a regulator fails.
2
).
2
gases.
psi