Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
English
1 Turn the nail holder about 90 degrees
counterclockwise.
2 Slide in vertical direction possible.
Lift or lower the nail holder to accept diff erent
length nails.
3 Adjust the plate to the nail length reference points
on the magazine cover and turn the nail holder 90
degrees clockwise until you hear "click".
2
mm
mm
mm
inch
inch
inch
1
1
32 38
32 38
32 38
1
1
45
45
45
2
2
2
2
3
Magazine
Nail holder
(3) Place the coil nails into the magazine.
Uncoil enough nails to reach the driving hole.
Magazine
(4) 1 Uncoil enough nails to reach the driving hole.
Wire collated nails
2 Insert the fi rst nail into the driving hole and the
second nail between the two pawls of the feeder.
3 Fit the nail heads in the guide slot.
Driving hole
First nail
Nail Guide
2 3
2
14
1
/
1
/
1
1
4
2
1
/
3
4
2 2
/
1
1
1
1
1
1
1
4
4
2
2
4
3
3
4
4
2
/
2
/
3
1
2
2
1
1
8
2
4
4
3
3
2
2
1
1
3 3
8
8
2
2
1
Nail holder
Nails
Guide slot
4
1
Guide surface
Feeder
Plastic sheet collated nails
2 Insert the fi rst nail into the driving hole and the
second nail between the two pawls of the feeder.
3 Fit the nail head and upper side of the plastic
sheet in the guide slot.
Fit the lower side of the plastic sheet in the guide
slot for plastic sheets.
First nail
3
Pawl 1
Driving hole
4 Pulling the nails to the right, swing the nail guide
closed.
(5) Close the magazine cover fi rst and swing the nail
guide closed.
Knob
Nail guide
NOTE: Be careful not to deform the collated wires and
not to disengage the nails with the guide surface.
Otherwise, the nail guide will not close correctly.
(6) Make sure that the knob is correctly locked.
Guide slot
2 3
4
1
Guide slot for
plastic sheet
Guide
surface
2
Pawl 2
Magazine cover
Publicidad
Tabla de contenido
