Cutting Off The Sheet; Using The Nose Cap - Metabo HPT NV 75A5 Instrucciones Y Manual De Seguridad

CUTTING OFF THE SHEET

Tear off the output sheet in the direction of the arrow when
using the sheet collated nails.
Sheet

USING THE NOSE CAP

● When attaching or detaching the nose cap,
be sure to remove your fi nger from the trigger
and disconnect the air hose from the nailer.
If you like to protect the surface of workpiece against
scratches or markings made by the push lever, attach the
accessory nose cap to the push lever.
1 DISCONNECT AIR HOSE FROM NAILER.
2 Put the nose cap to the toe of the push lever.
NOTE:
● The nose cap may reduce nailing depth due to its
thickness. Re-adjustment of nailing depth is required.
Push Lever
Nose Cap
WARNING
Nose
Hole Do not connect
1
air hose
Protrusion (Inward)
Nose cap can be removed from the push lever using a
screwdriver or thin rod.
Push lever
Nose cap
Nose cap can be stored on the magazine as shown below.
Magazine
Nose cap
RAFTER HOOK
An included hook can be attached by using three M5 x 16
fl ange bolts which are included with the tools.
When the tool is detached from the hose and not in use,
the hook can be used to store the unit.
● When attaching or detaching the hook, make
sure the hose is detached and the nails are
removed from the tool.
(1) How to attach the hook
Hexagonal bar wrench for M5
2
1
Main unit
Fig. 1
English
Screwdriver
WARNING
Fig. 2
19