damage before operation each
time. Do not put the device into
operation with a damaged pow-
er supply cable. Have a dam-
aged power supply cable
replaced immediately by the au-
thorised customer service / qual-
ified electrician. Do not
damage the power supply and
extension cable by running over
it, crushing or yanking it or simi-
lar. Protect the power supply ca-
ble from heat, oil and sharp
edges. Only use the mains
connection cable prescribed by
the manufacturer, including
when replacing the cable. For
order no. and type see operating
instructions. Unsuitable electri-
cal extension cables can be
dangerous. Only use approved
and appropriately marked elec-
trical extension cables with a
sufficient cable cross section for
outdoors. Only replace cou-
plings on the power supply or
extension cable using those with
the same water density and the
same mechanical strength.
CAUTION In case of longer
breaks in operation and after
use, switch off the device at the
main switch / device switch and
pull the mains plug.
ATTENTION Switch-on proce-
dures will generate short-term
voltage drops. Unfavourable
mains conditions may cause
other devices to be impaired.
10
In case of a network imped-
ance of less than 0.15 ohms, no
malfunctions are to be expected.
Water connection
WARNING The device
must not be started up if the
high-pressure hose is damaged.
Replace a damaged high-pres-
sure hose at once. Only those
hoses and connections recom-
mended by the manufacturer
may be used. For order no. see
operating instructions. The
screw connections of all connec-
tion hoses must be leak-tight.
ATTENTION Observe the reg-
ulations at your water distribu-
tion company.
DANGER When using the
device in hazard zones (e.g. ser-
vice stations), adhere to the re-
spective safety regulations.
Operation in explosive atmos-
pheres is prohibited. Never
suction solvents, liquids contain-
ing solvents or undiluted acids.
This includes e.g. petrol, paint
thinner or heating oil. The spray
mist is highly flammable, explo-
sive and poisonous. Damaged
wheels / tyre valves are ex-
tremely dangerous. Damaged
wheels / tyre valves can be
damaged by the high-pressure
jet and explode. The first sign of
this is discolouration of the tyres.
Keep a spray distance of at least
English
Operation