Flex L 3709-115 Instrucciones De Funcionamiento Originales página 21

L 3709 -115, L 3709 -125, LE 9-10 125, L 10-10 125, L 801, L 1001
Rotate safety guard to the required

position.
Quick-release guard
(LE 9-10 125, L 10-10 125, L 1001)
WARNING!
When using the angle grinder for roughing
or cutting, never work without the guard.
Pull out the mains plug.

Loosen the clamping lever (a).

Adjust the guard.

Tighten screw (b) until the clamping lever

can just be clamped by hand.
Retighten the clamping lever.

A special quick-release cutting guard

must be used for cutting.
Attaching or changing the grinding
tool
Pull out the mains plug.

Press and hold down the spindle

lock (1.).
Using the face spanner, loosen the

clamping nut on the spindle in an anti-
clockwise direction and remove (2.).
Insert the grinding wheel in the correct

position.
Screw the clamping nut with flange face

up, onto the spindle.
Press and hold down the spindle lock.

Tighten the clamping nut with the face

spanner.
Insert the mains plug into the socket.

Switch on the angle grinder (without

locking into position) and leave the angle
grinder running for approx. 30 seconds.
Check for imbalances and vibrations.
Switch off the angle grinder.

21