Dash Disassembly - Metra 99-7612 Instrucciones De Instalación

1. Unclip and remove the trim panel
surrounding the display and
including the a/c vents. (Figure A)
2. Remove (2) Phillips screws
exposed behind vent/display trim
panel. b(Figure B)
3. Unclip and remove the lower trim
panel around the bottom of the
radio panel. (Figure C)
Continued on next page

Dash Disassembly

(Figure A)
(Figure B)
(Figure C)
99-7612
4. Remove (1) Phillips screw per side
of radio chassis exposed behind
lower trim panel. (Figure D)
5. Remove radio/climate control
assembly from the sub dash.
6. Remove (4) Phillips screws securing
the radio chassis to the factory
radio trim panel. Lift up slightly and
proceed to step 7. (Figure E)
7. Unlock the connector on the switch
panel and remove the cable joining
the chassis and switch panel.
(Figure F)
Continued on next page
(Figure D)
2
(Figure E)
Left side
Right side
(Figure F)