Würth HLG 1600 BASIC Traducción Del Manual De Instrucciones De Servicio Original página 14

Operation
Attention!
Prior to use, check that the specifications of your
mains power supply correspond to the mains
voltage and mains frequency indicated on the
name plate.
HLG 1600 BASIC
S itching on
▸
Set the air quantity level at the switch [4].
The temperature is permanently pre-set for both air
3
quantity levels and cannot be changed.
Air quantity level 1 350 °C
Air quantity level 2 550 °C
▸
Allow the device to heat up for 3 minutes before
use.
S itching o
▸
Set the switch [4] to 0.
▸
Allow the device to cool down after use. To do so,
position it on its support points [3].
HLG 2000 COMPACT
S itching on
▸
Set the air quantity level at the switch [4].
▸
Set the temperature at the rotary knob [5].
It can be set from 80 - 620 °C in both air uantity
3
level settings. The scale [6] is for orientation:
Position 1: Temperature about 80 °C
Position 9: Temperature about 620 °C
▸
Allow the device to heat up for 3 minutes before
use.
S itching o
▸
Turn the rotary knob to 0.
▸
Position the device on its support points (see
section Setting the device down ) and leave it to
continue running for 5 minutes with the selected
air quantity level so that the device cools down.
▸
Set the switch [4] to 0.
HLG 2300-E POWER
S itching on
▸
Position the switch [4] at level 2 (work level).
▸
Set the air quantity level and the temperature
(see sections Adjusting the temperature and
Adjusting the air uantity )
14
S itching o
Information
Level 1 should be used for quick device
cooling. It is not necessary to decrease
the temperature via the display when
using it.
▸
Set the switch [4] to level 1.
▸
Position the device on the support points (see
section Setting the device down ) and leave it to
continue running for 5 minutes.
▸
Set the switch [4] to 0.
Adjusting the temperature
▸
Set the desired temperature using button "+" or "-".
The device heats up (symbol
3
down symbol ( flashes).
As soon as the desired temperature is reached,
3
the symbol stops flashing.
Adjusting the air uantity
▸
Press the selection button "".
Symbol flashes.
3
▸
Set the desired air quantity using button "+" or "-"
(there are 5 selectable levels).
▸
Confirm with selection button "" or wait until the
symbol comes on permanently.
The selected air quantity is displayed.
3
Standby operation
Switching on standby operation.
▸
Keep the selection button "" pressed for at least
2 seconds.
The symbol appears in the display.
3
Standby operation is activated.
3
Switching o standby operation
▸
Press the selection button "".
The symbol disappears in the display.
3
Standby operation is switched o .
3
Configuring the device
▸
Set the switch [4] to 0.
▸
Press the "+" and "-" buttons simultaneously and
set the switch [4] to level 1 while both buttons are
depressed.
Device configuration C0 appears on the
3
display.
▸
To access the next configuration, press the "+"
button.
▸
To access the previous configuration, press the "-"
button.
flashes) or cools