Prior To Operation - DeWalt D23620 Traducido De Las Instrucciones Originales

EN GLI SH
1. Adjust the depth of cut to 0 mm to access the
clamping screws of the riving knife.
2. Loosen the screws (u) and pull out the riving
knife to its maximum length.
3. Adjust the clearance.
4. Tighten the screws (torque: 4 - 5 Nm).
Mounting and Adjusting the Parallel
Fence (fi g. 7)
The parallel fence (o) is used for cutting parallel to
the edge of the workpiece.
MOUNTING
1. Slacken the locking screw (v) as to allow the
parallel fence to pass.
2. Insert the parallel fence (o) in the saw shoe (f) as
shown.
3. Tighten the locking screw (v).
ADJUSTING
1. Slacken the locking screw (v) and set the
parallel fence (o) to the desired width.
2. Tighten the locking screw (v).

Prior to Operation

• Make sure the guards have been mounted
correctly. The saw blade guard must be in
closed position.
• Make sure the saw blade rotates in the direction
of the arrow on the blade.
OPERATION
Instructions for Use
WARNING: Always observe the safety
instructions and applicable regulations.
WARNING: To reduce the risk
of serious personal injury, turn
tool off and disconnect tool from
power source before making any
adjustments or removing/installing
attachments or accessories.
WARNING: Always observe the safety
instructions and applicable regulations.
• Ensure the material to be sawn is
firmly secured in place.
• Apply only a gentle pressure to the
tool and do not exert side pressure on
the saw blade.
• Avoid overloading.
30
• Do not use excessively worn saw
blades.
• Do not use your saw for pocket cuts.
Proper Hand Position (fi g. 8)
WARNING: To reduce the risk of
serious personal injury, ALWAYS use
proper hand position as shown.
WARNING: To reduce the risk of
serious personal injury, ALWAYS hold
securely in anticipation of a sudden
reaction.
Proper hand position requires one hand on the front
handle (c), with the other hand on the main handle
(x).
Switching On and Off (fi g. 2)
For safety reasons the on/off switch (a) of your tool is
equipped with a lock-off button (b).
1. Press the lock-off button to unlock the tool.
2. To run the tool, press the on/off switch (a). As
soon as the on/off switch is released the lock-
off switch is automatically activated to prevent
unintended starting of the machine.
WARNING: Do not switch the tool on
or off when the saw blade touches the
workpiece or other materials.
WARNING: Do not operate the spindle
lock while the tool is running.
Guiding the Tool (fi g. 1, 2)
1. For optimum results, clamp the workpiece
bottom up.
2. Follow the line drawn on the workpiece using
the mark (m).
In case of a bevel angle of 45° follow the line
drawn on the workpiece using the mark (l).
3. Lead the cord away in line with the rear of the
tool.
Dust Extraction (fi g. 1)
WARNING: Risk of dust inhalation.
To reduce the risk of personal injury,
ALWAYS wear an approved dust mask.
Your tool is fitted with a dust extraction outlet (e).